Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The notification for six different posts - Clerk, PRO, Lecturer, Accountant, Watchman and Principal- are to be released on consecutive Fridays. The schedule of the releasing is to be in accordance with the following conditions: (i) Clerk post must be released a week before the Watchman post. (ii) Lecturer post must not be released immediately after the first release. (iii) PRO post must be released on the Friday following the Friday on which the Principal post is released. (iv) Accountant post must be released on the fifth Friday and should not be immediately preceded by the PRO post. (v) The Watchman post must not be released last. Which of the following notifications will be released immediately after the PRO post?
What is the output from differential screws when pitch of the two screws is 12mm and 8mm? Also the nut is rotated by applying a force of 120N at a radius of 300mm and the two screws remain stationary. The torque of raising and lowering for the two screws is 5k N-mm and 2.5k N-mm where k is the effective axial weight on the screw.
What is the efficiency of differential screws when pitch of the two screws is 12mm and 8mm? The nut is rotated by applying a force of 120N at a radius of 300mm and the two screws remain stationary. The torque of raising and lowering for the two screws is 5k N-mm and 2.5k N-mm where k is the effective axial weight on the screw.
‘Grand Slam’ refers to winning certain major tennis tournaments in a single calendar year. The name of the tournaments are A. Australian Open, French Open and US Open B. Australian Open, French Open, Wimbledon and US Open.  C. French Open, US Open and Wimbledon D. French Open, US Open, Wimbledon and Olympic
Which of the following methods can be used for supporting work on the table? I) Clamped in a vice II) Clamped on a V block III) Clamped on the angle plate
The threading tool is clamped in the tool post on the compound slide.
Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
Based on the following table, in which months the number of screws produced was more than the average number of screws produced in each month? Month Number of Screws Produced (in thousands) January 200 February 300 March 250 April 250 May 230 June 270
Three statements are given, followed by three conclusions numbered I, II and III. Assuming the statements to be true, even if they seem to be at variance with commonly known facts, decide which of the conclusions logically follow(s) from the statements. Statements: Some Nails are Hammer. Some Screws are Pliers. All Hammer are Pliers. Conclusions: I. Some Nails are Pliers. II. Some Screws are Hammer. III. Some Nails are Screws.
In the question two statements are given, followed by two conclusions, I and II. You have to consider the statements to be true even if it seems to be at variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statements. Statement I: All bolts are nails Statement II: Some screws are bolts Conclusion I: All nails are screws Conclusion II: All screws are nails