Bissoy.com
Doctors Medicines MCQs Q&A

Process capability can be expressed as a percentage outside of the specifications.

Process capability can be expressed as a percentage outside of the specifications. Correct Answer True

We use the process mean, spread, and the shape of the probability plot of the quality characteristic for the estimation of Process Capability. Alternatively, Process capability can be expressed as a percentage outside of the specifications.

Related Questions

A process capability ratio Cp=____________ indicates the fallout rate of 1 ppm for one-sided specifications for a normally distributed process.
What is the minimum value of Process Capability Ratio Cp for one sided specifications, for a new process which is normally distributed?
Process capability compares the output of an in-control process to the specification limits by using capability indices.
The figure below shows a symbolic representation of the surface texture in a perpendicular lay orientation with indicative values (I through VI) marking the various specifications whose definitions are listed below. P: Maximum Waviness Height (mm); Q: Maximum Roughness Height (mm); R: Minimum Roughness Height (mm); S: Maximum Waviness Width (mm); T: Maximum Roughness Width (mm); U: Roughness Width Cutoff (mm); The correct match between the specifications and the symbols (I to VI) is
The process capability of a machine is defined as the capability of the machine to
M, N, O, P, Q, Rand S are sitting around a circular table facing the center and away from the center. O sits second to the left of R, who faces outside. N sits adjacent to M. S is not the neighbor of R. O faces inside. Q is not neighbor of N. M sits third to the right of R and faces outside. The neighbors of M face inside. N is not neighbor of O. The neighbors of R face outside the circle. Who sits second to the right of Q?
Consider the given statement and the following assumptions. Decide, which of the assumptions is implicit in the statement and choose your answer accordingly: Statement: The civic authority has decided that all the factories located inside the city limit be shifted outside to reduce the level of environmental pollution in the city. Assumptions: I. The pollution level in the city in future may reduce after these factories are shifted outside the city limit II. Enough usable land is available outside the city limit for these factories III. Many of these factories may shift to some other smaller towns to remain profitable
A hollow sphere (k = 30 W/m K) of inner radius 6 cm and outside radius 8 cm has a heat generation rate of 4000000 W/m3. The inside surface is insulated and heat is removed by convection over the outside surface by a fluid at 100 degree Celsius with surface conductance 300 W/m2 K. Make calculations for the temperature at the outside surfaces of the sphere
Directions : In each of the following questions a statement is given, followed by three conclusions. Give answer :

Statement : The civic authority has decided that all the factories located inside the city limits be shifted outside to reduce the level of environmental pollution in the city.

Assumptions :
I. The pollution level in the city in future may reduce after these factories are shifted outside the city limit.
II. Enough usable land is available outside the city limit for these factories.
III. Many of these factories may shift to some other smaller towns to remain profitable.
A student appeared in the Mock CAT. The test paper contained 3 sections namely QA, DI and VA. The percentage marks in all VA was equal to the average of percentage marks in all the 3 sections. Coincidentally, if we reverse the digit of the percentage marks of QA we get the percentage marks of DI. The percentage marks in VA scored by student could be: