Bissoy.com
Doctors Medicines MCQs Q&A

In rotary swaging, a unitary or single die is used during the processing of metallic bar or rod.

In rotary swaging, a unitary or single die is used during the processing of metallic bar or rod. Correct Answer False

In rotary swaging process, the radial motions of the dies are very important for most of the applications. In general, a die set mainly consists of four die segments which basically depends on the type of application or use, and also depends on the size of the machine tool. In special cases of swaging, the number of die sets can be used up to eight dies.

Related Questions

A hollow rod has frictionless inner walls. Inside the rod are two small spheres that are kept on either side of the centre of rod. The rod is rotated about its central axis which is perpendicular to the plane of rotation. If the rod had been rotated by an impulsive torque which gave it an instantaneous angular velocity of 5rad/s, what will be the angular velocity after some finite but long time ‘t’? Assume no external forces act on rod after the impulse. Also state what will happen to the spheres in the centre of the rod. The rod has a mass =2kg & length =10cm. The two spheres have a mass =1kg each.
A single piece or unitary part of the metallic die is used for making castings in die casting.
The figure shows a 5 cm diameter rod, 90 cm long, which is having its lower face grinded smooth. The remainder of the rod is exposed to 32 degree Celsius room air and a surface coefficient heat transfer equal to 6.8 W/m2 degree exists between the rod surface and the room air. The grinder dissipates mechanical energy at the rate of 35 W. If thermal conductivity of rod material is 41.5 W/m degree, find the temperature of the rod at the point where the grinding is taking place
Piston diameter = 0.24 m, length of stroke = 0.6 m, length of connecting rod = 1.5 m, mass of reciprocating parts = 300 kg, mass of connecting rod = 250 kg; speed of rotation = 125 r.p.m; centre of gravity of connecting rod from crank pin = 0.5 m ; Kg of the connecting rod about an axis through the centre of gravity = 0.65 m Find angular acceleration of connecting rod in rad/s2.
A metallic bar at 37°C is placed inside an oven whose interior is maintained at a temperature of 1100 K. The absorptivity of the bar (at 37°C) is a function of the temperature of incident radiation and a few representative value are given below: Temp (K) 310 700 1100 α 0.8 0.68 0.52   The rate of emission by the metallic bar is (in kW/m2)
Which of the following option is correct about oxidation and reduction? The addition of a non-metallic elements (removal of metallic elements) is called oxidation. The addition of metallic elements (removal of non-metallic elements) is called reduction.
Which of the following is true regarding the metallic nature of minerals? I. Metallic nature is directly proportional to electropositive nature. II. Metallic nature in period increases. III. Metallic nature in groups increases.
A steel and a copper bar are joined end to end. The area of the steel bar is half the area of the copper bar. Their lengths are equal to 10cm each. Temperature of free ends of steel & copper rod are 0°C & 100°C respectively. KS = 50 J/smK & KC =384 J/smK. Calculate equivalent thermal conductivity of the combined bar.
A charged metallic rod is touched with a metallic sphere which is grounded and when the rod is removed, the charge on the sphere will be:
Given a rod of length n and the selling prices of all pieces smaller than equal to n, find the most beneficial way of cutting the rod into smaller pieces. This problem is called the rod cutting problem. Which of these methods can be used to solve the rod cutting problem?