Bissoy.com
Doctors Medicines MCQs Q&A

Stretch forming is a sheet metal forming operation in which shearing is taking place to deform the material.

Stretch forming is a sheet metal forming operation in which shearing is taking place to deform the material. Correct Answer False

Stretch forming is a type of sheet metal forming process in which the metallic sheet is intentionally stretched and bent simultaneously to produce different shapes of the stretched sheet metal. The metal sheet is generally held by jaws at the ends. And then the sheet is stretched by the help of punch.

Related Questions

Consider the following in case of high-energy forming processes: 1. The evacuation between die and blank in explosive forming is done by a vacuum pump. 2. The pressure waves produced in water in explosive forming deform the blank to the die shape. 3. The electrohydraulic forming makes use of discharge of large amount of electrical energy used in a capacitor bank. 4. In Petroforge, the piston is moved by combustion of fuel moving at the rate of 150-200 m/s. Which of the above are correct?
Tangential stretch forming and simple stretch forming are quite similar to each other.
A right angled triangle was cut from a rectangular sheet of length 20 cm whose perimeter is same as a square of side 30 cm. If height of the triangle is same as breadth of rectangular sheet and base is 1/4th of length of sheet then, the area of the remaining sheet is what percent of area of the whole sheet?
At Lions High school 100 students are taking chemistry and 80 students are taking Biology. If 20 students are taking both chemistry and Biology , what is the ratio of the students taking only chemistry to the number taking only Biology?
Select the correct answer choice of the following Question : "At Lions High School 100 students are taking Chemistry and 80 students are taking Biology. If 20 students are taking both Chemistry and Biology, what is the ratio of the students taking only Chemistry to the number taking only Biology?
If the sheet is rolled along certain direction of rolling, the grain will deform in the sheet. The maximum deformation of grains occurs at the _____________
High volume rate of production can be possible by stretch sheet metal forming process.
In a six-digit number, the digit of thousands place is 4. The digit at ten's place is double that of digit at thousand's place and digit at hundreds places is half of the digit at thousand’s place. The digit at unit's place is half of the digit at hundred's place. Digit at Ten thousand's place is sum of the digits at thousands and hundreds place and digit at lakh's place is half the digit at ten thousands place. What will be the number?
An electric bus has onboard instruments that report the total electricity consumed since the start of the trip as well as the total distance covered. During a single day of operation, the bus travels on stretches M, N, O and P, in that order. the cumulative distances travelled and the corresponding electricity consumption are shown in the Table below: Stretch Cumulative distance(km) Electricity used (kWh) M 20 12 N 45 25 O 75 45 P 100 57 The stretch where the electricity consumption per km is minimum is 
What should be the appropriate thickness of the metal sheet when it is used as a raw material for the sheet metal operations?