Bissoy.com
Doctors Medicines MCQs Q&A

The metal forging operation can be performed manually or by automation.

The metal forging operation can be performed manually or by automation. Correct Answer True

Metal forging is a forming operation that performs hammering to shape the metal component. In forging process, the metal component is heated sufficiently, and then it is hammered by using a hammer which can be performed manually or by automation, depending on the scale of production and properties required in the forged metal component.

Related Questions

Precision forging is a type of forging operation in which the metal stocks and dies are controlled very tightly.
Forging is a metal forming operation in which the metal is stretched to form the desired shape of a metal part.
A circuit breaker is a piece of equipment which can (i) make or break a circuit either manually or by remote control under normal conditions. (ii) break a circuit automatically under fault conditions. (iii) make a circuit either manually or by remote control under fault conditions Choose the correct answer. 
The metal forging operation can only be performed by manual means.
Consider the following statements regarding defects in forgings 1. Flakes are internal breaks or ruptures occurring in some grades of alloy steel. 2. Die shift is caused by misalignment between the top and bottom forging dies. 3. Fins and rags are small projections or loose metal driven into the surface of the forging. Which of the above statements are correct ? 
For the minimum metal loss, the flash-less forging is better than the impression die forging.
A cone shaped die is used in the orbital forging for the forging of metal parts.
Isothermal forging is also known as cold forging operation.
The following statements are made regarding the Open Circuit Test on the single-phase transformer: 1. It is performed on the LV side. 2. It is performed at rated current. 3. It helps in the calculation of equivalent leakage impedance. 4. It is performed on the HV side. 5. It is performed at rated voltage. 6. It gives magnetizing current and core loss. 7. It helps in the determination of voltage regulation. 8. It gives the turn ratio. From these, which statements are correct?
Consider the following statements about the doctrine of frustration:
1. Act has become impossible to be performed.
2. Act cannot be performed because of application of some law recently enacted.
3. Act cannot be performed because of the non-availability of raw material.
4. Act cannot be performed by defendant due to his accident.
Which of the statements given above are correct?