Bissoy.com
Doctors Medicines MCQs Q&A

It is not possible to use cutting dies for the metal drawing operations.

It is not possible to use cutting dies for the metal drawing operations. Correct Answer True

Cutting dies are mainly used for cutting the metal. They use shearing action for cutting the metal sheet. Various cutting dies are used such as blanking dies, piercing dies, perforating dies, notching dies, shaving dies and nibbling dies. And it is not possible to use cutting dies for the metal drawing operations.

Related Questions

Which of the following dies is not the type of cutting dies in the metal cutting operations?
In how many of the following applications, wire cut EDM can be used? – Manufacturing of progressive, blanking and trim dies – Extrusion dies – Cutting difficult to machine materials like hastaloy, inconel and titanium – Cutting narrow slots and keyways – Manufacturing of parts where burrs can’t be tolerated.
Which one of the following is true with regard to a CPU having a single interrupt request line and single interrupt grant line? i) Neither vectored nor multiple interrupting devices is possible. ii) Vectored interrupts is not possible but multiple interrupting devices is possible. iii) Vectored interrupts is possible and multiple interrupting devices is not possible. iv) Both vectored and multiple interrupting devices are possible.
In the metal forming operations, forming dies are also called as progressive dies.
A machine part is drawn two times with different scales. The ratio of 1st drawing’s R.F. to 2nd drawing R.F. with respect to the actual object is found to be 2. The length of the second drawing is 10 mm. Find the 1st drawing length.
Which among the NC operations given below are continuous path operations?Arc Welding (AW), Drilling (D), Laser Cutting of Sheet Metal (LC), Milling (M), Punching in Sheet Metal (P), Spot Welding (SW)
Which among the NC operations given below are continuous path operations?
Arc Welding (AW), Drilling (D), Laser Cutting of Sheet Metal (LC), Milling (M), Punching in Sheet Metal (P), Spot Welding (SW)
Consider the following statements: 1. HSS tools wear very rapidly, whereas in cemented carbide tools, even though hardness is retained, crater wear can occur due to solid-state diffusion. 2. Cutting tools made of Super-HSS, also known as cobalt-based HSS, are made by adding 2% to 15% of cobalt which increases the cutting efficiency at heavier cuts by increasing the hot hardness and wear resistance. 3. Tools failure due to excessive stress can be minimized by providing small or negative rake angles on brittle tool materials, protecting tool tip by providing large side-cutting edge angles, and honing a narrow chamfer along the cutting edge. Which of the above statements are correct?
Flank wear occurs mainly on the 1. Nose part of the cutting tool 2. Front relief face and side relief face of the cutting tool 3. Face of the cutting tool at the shortest distance from the cutting edge Which of the above is/are correct?
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image