Bissoy.com
Doctors Medicines MCQs Q&A

Crucible furnaces are economical for melting metal, but heat loss is the major problem in the crucible furnaces.

Crucible furnaces are economical for melting metal, but heat loss is the major problem in the crucible furnaces. Correct Answer False

In crucible furnaces, there is no direct collision of flame on the material. And the heat loss to the outside surrounding is restricted by the refractory walls. However, the energy efficiency of the crucible furnace is low with approximately 60% of the heat loss affected by the radiation and the temperature control is also very difficult in the crucible furnaces.

Related Questions

Square crucible furnaces are more efficient than the round crucible furnaces.
The heat to transform the metal from solid to liquid phase at the melting point, which depends on the metal’s heat of fusion. Calculate the unit energy for melting if the melting temperature is 1000K? (K = 3.33 * 10-6).
One cubic meter of some alloy is heated in a crucible from room temperature to 100 degree Celsius above its melting point for casting. The alloy density = 7.5 g/cm3, melting point = 800 0C, specific heat = 0.33 J/gC in the solid state and 0.29 J/gC in liquid state and heat of fusion = 160 J/g. How much heat energy must be added to accomplish the heating, assuming no losses? Ambient temp = 25 °C. Density of solid and liquid are same.
Consider the figures of a metal ball and a metal ring given below.
The metal ball can just pass through the hole of a metal ring formed out of a strip. When the ball is heated it gets stuck. But when the metal is heated
Heat and Thermodynamics mcq question image
Which row of the following table correctly matches the terms with the respective processes of state-change?   Change of State   Gas to liquid Liquid to solid Solid to liquid 1. Condensation Melting Solidification 2. Condensation Solidification Melting 3. Evaporation Melting Solidification 4. Evaporation Solidification Melting
A gas tungsten arc-welding operation is performed at a current of 500 A and voltage of 20 V. The melting factor f2 = 0.5, and the unit melting energy for the metal Um = 10 Jmm-3. Calculate the volume of metal welded? (Heat transfer factor is 0.7)
A Carnot heat engine receives heat at 750 K and rejects the waste heat to the environment at 300 K. The net work output of the heat engine is used to drive a Carnot refrigerator, whose COP is 6.14. If the heat removal rate from the refrigerated space is 6.6 kW, determine the rate of heat supply to the heat engine?
Metal 'A' displaces metal 'B' from its salt solution, but not able to displace metal 'C' from its salt solution. Metal 'B' displaces metal 'D' from its salt solution. Which of the following depicts correct order of reactivity of metals. 
The recrystallization behaviour of a particular metal alloy is specified in terms of recrystallization temperature, which is typically 1/3rd of the absolute melting temperature of a metal or an alloy and depends on several factors including the amount of 1. cold working and purity of the metal and alloy 2. hot working and purity of the metal and alloy Which of the above is/are correct?
Consider the following statements regarding heat waves in India.  I. Heat waves mostly occur over Rajasthan, Punjab and Haryana towards the end of April but they mainly take place in May.  II. Any heat wave lasts for around 4-5 days.  III. If there is an increase in temperature by 6-7 degrees Celsius above normal, that is known as the Moderate Heat Wave whereas if it is 8 degree Celsius or more, that is known as Severe heat wave.  Which among the above statements is/are correct regarding the heat waves?