Bissoy.com
Doctors Medicines MCQs Q&A

The thickness of the metallic wall of the mould can be used to determine the wall thickness of the casting part in slush casting.

The thickness of the metallic wall of the mould can be used to determine the wall thickness of the casting part in slush casting. Correct Answer True

The wall thickness of the casting part not only determined by the thickness of the metallic wall of the mould, but it can also be obtained by considering the other factors like length of time the mould is preheated, and the amount and type of molten metal are used in the process of slush casting.

Related Questions

In permanent mould casting, only the metallic type of cores can be used, as the mould material used is also metallic.
The casting processes that require expendable moulds are
P. Investment casting
Q. Low pressure casting
R. Shell moulding
S. Slush casting
At the mould exit of a continuous caster, the metal consisting of a solidified shell with a liquid metal core exits at the rate of 35 kg S-1. Given that the latent heat of fusion is 3 × 105 J kg-1 and the total rate of heat removal by the mould is 4.2 × 106 W, the mass fraction of solid at the mould exit is . . . . . . . .
Assume that both while solid and liquid remain at the melting point, they are in the mould.
Which of the following option is correct about oxidation and reduction? The addition of a non-metallic elements (removal of metallic elements) is called oxidation. The addition of metallic elements (removal of non-metallic elements) is called reduction.
Which of the following is true regarding the metallic nature of minerals? I. Metallic nature is directly proportional to electropositive nature. II. Metallic nature in period increases. III. Metallic nature in groups increases.
Porosity in the moulding part cannot affect the casting part in slush casting process.
In permanent mould casting, the mould is pre-heated to its operating temperature before the actual use of mould.
A permanent mould is used in the slush casting with some variations for the making of castings.
Which of the following moulds is used in slush casting, in which mould is broken to remove the castings?
When a pattern is to be withdrawn from the mould, it is first shaken, by striking over it from side to side, so that its surface may be free of the adjoining sand wall of the mould. That causes the size of the mould cavity increases a little and a negative allowance is to be provided in the pattern to compensate the same, is known as: