What is the best definition of Engineering Shear Strain (γij)?

What is the best definition of Engineering Shear Strain (γij)? Correct Answer It is the total angle of shearing under a state of simple shear

The Engineering Shear Strain is defined as the total angle of the shearing under the state of simple shear. It implies that it is always accompanied with a rotation of an element. It differs from the tensor shear strain in the way that tensor shear strain doesn’t accompany any form of rotation.
Bissoy MCQ

Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
The true strain rate is given as ϒ, and conventional strain rate is given as ε. The engineering strain is equal to e. The relationship between conventional strain rate and true strain rate is _______
The relationship between the true strain and engineering strain is given as _____ Where e=conventional strain, ε= Engineering strain
The relation between Engineering Shear Strain (γ12) and the Tensor Shear Strain (ε12) is given by __________
Shear stress versus shear rate behavior of four different types of fluids (I, II, III and IV) are shown in the figure below.
Basic Principles of Biotechnology mcq question image
Which one of the following options is correct?
What is the relationship between engineering stress and true stress? Given that; s = engineering stress, σ = true stress, e = engineering strain, ε = true strain. d) σ = se+1
The strain rate calculated from engineering strain and correct strain gives the same result.
The strain energy stored in a body due to shear stress, is (where $$\tau $$ = Shear stress, C = Shear modulus and V = Volume of the body)
Given the shear modulus(G) for aluminum as 2.4e+10 N/m2 and the shear strain is given as 6e-5. What is the value for shear stress?
The ultimate shear force at a section of an RCC beam is 300 kN. The shear resisted by concrete is 77.5 kN. What is the shear for which shear reinforcement is required?