Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Two centrifugal pumps P and R are available for use in a pipe flow system and their head-discharge characteristics are as follows. Pump P Pump R Discharge (cumecs) Head (m) Discharge (cumecs) Head (m) 0 40 0 45 0.12 35 0.14 40 0.2 28 0.24 35 0.3 18 0.3 28   The following statements (S1, S2, and S3) pertain to the head and discharge values during actual operation. Neglect losses in the system. Which of the following statements are correct? S1: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 35 m. S2: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 70 m. S3: When the two pumps P and R are connected in series, the discharge is 0.3 cumecs corresponding to a head of 46 m.
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
What are the surface roughness values obtained while machining spherical surfaces using Electro discharge machining?
Thickness of 8 tyres L, M, N, O, P, Q, R and S is compared. Thickness of no two tyres is same. Thickness of N is more than L but less than 6 tyres. Thickness of O is more than M but less than Q. Thickness of P is less than only two tyres. Thickness of Q is not more than P. Which of the following statement is not correct?
Which of the following electrodes are used for machining spherical surfaces in Electro discharge machining?
Which motion of tool is used for machining spherical surfaces in Electro discharge machining?
How much amount of burr is produce when we use Wire Electro discharge machining for machining of work pieces?
During roughing process through Electro discharge machining, what is the thickness of layer formed?
During finishing process through Electro discharge machining, what is the value thickness of layer formed?
In the electro-discharge machining operation, the section thickness should be low to work efficiently.