Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Mr.Rohan while helping the students of Class IV in adding and subtracting fractions observed that several students are not able to complete the addition of two improper fractions. He gave a small test with questions from the addition of proper fractions (one item of addition of two similar fractions, three items from the addition of proper and improper fractions, and four items from the addition of improper fractions). He analyzed the responses of each student and found that nearly 45% of students were not clear in adding proper with improper fractions which were affecting their performance in adding two improper fractions. He, therefore, focused on developing the understanding of improper fractions and their addition with proper fractions after which he proceeded to teach the addition of two improper fractions. Which kind of assessment is depicted by this situation?
Two centrifugal pumps P and R are available for use in a pipe flow system and their head-discharge characteristics are as follows. Pump P Pump R Discharge (cumecs) Head (m) Discharge (cumecs) Head (m) 0 40 0 45 0.12 35 0.14 40 0.2 28 0.24 35 0.3 18 0.3 28   The following statements (S1, S2, and S3) pertain to the head and discharge values during actual operation. Neglect losses in the system. Which of the following statements are correct? S1: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 35 m. S2: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 70 m. S3: When the two pumps P and R are connected in series, the discharge is 0.3 cumecs corresponding to a head of 46 m.
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
Which motion of tool is used for machining spherical surfaces in Electro discharge machining?
Consider the following types of motion.  A. Periodic Motion B. Straight Line Motion C. Rotational Motion D. Circular Motion The motion of a pendulum can be categorised in which of the following types of motion?
The following question, there are three statements I, II and III. Read the question carefully and mark your answer according to which statements(s) is/are sufficient to the answer the question. What proportion of liquid of type C is there in the tank of capacity 60 liters after 2 minutes if the tank is initially empty? Statement I: Three pipes P, Q, R fill the tank in 15 minutes, 12 minutes and 10 minutes respectively Statement II: When the tank was empty all the three pipes are opened and they discharge three different types of liquid Statement III: Pipe P discharge type A liquid, pipe Q discharge type B liquid and Pipe R discharge type C liquid
What is correct about the dismissal of Vice President of Municipal Council ? a. He may be dismissed by No confidence motion. b. Signature of 1/6 members of council is essential in the resolution to introduce the No confidence motion. c. Signature of 1/10 members of council is essential in the resolution to introduce the No confidence motion. d. No confidence motion should be accepted by the Council by 2/3 majority. e. No confidence motion should be accepted by the Council by 3/4 majority. f. No confidence motion should be Passed by more than half of the total elected members and 2/3 majority of the members present and voting.
Which of the following electrodes are used for machining spherical surfaces in Electro discharge machining?
What are the surface roughness values obtained while machining spherical surfaces using Electro discharge machining?
How much amount of burr is produce when we use Wire Electro discharge machining for machining of work pieces?