Bissoy.com
Doctors Medicines MCQs Q&A

Higher material removal rates are associated with _________ feed rates and _________ tool diameters.

Higher material removal rates are associated with _________ feed rates and _________ tool diameters. Correct Answer Larger, larger

Rates of material removal are high, when feed rates are high and larger tool diameters.

Related Questions

Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
In choosing a research tool which of the following are important considerations? A. The validity of the research tool B. The reliability of the research tool C. cost involved in terms of time and resources for use of research tool. D. Face validity of the research tool E. Opinion of the research supervisor Select the correct answer from the following options:
Which of the following statements is/are with respect to rates in the building estimation? A) The rates for building estimation are usually taken from PWD schedule of rates, with appropriate escalation charges. B) Rates for different items in the estimate are the current rates for the completion of the items of work.
Discrepancies are sometimes observed between theoretical and actual metal removal rates and electrode feed rates.
Given below are four jumbled sentences. Select the option that gives their correct order. Interest rates, in turn, are a crucial determinant of how much firms and consumers want to spend. Conversely, a consumer may be lured into buying a new home if interest rates are low and mortgage payments are therefore more affordable. A firm faced with high-interest rates may decide to postpone building a new factory because the cost of borrowing is so high. The Federal Reserve System strongly influences the size and growth rate of the money stock, and thus the level of interest rates in the economy.
After GST and demonetisation, rising interest rates are set to hurt SMEs. Interest rates for loans against property (LAP) extended to small and medium sized enterprises (SMEs) are set to rise in the coming months of 2018 ‘ Rising interest rates, in addition to the muted operating environment for small businesses in India, will lead to an increase in delinquencies on LAP extended to SMEs’. The introduction of the goods and services tax (GST) in July 2017 and the government's demonetization policy have placed stress on the SME sector, which rising interest rates will exacerbate. Which of the following can be logically inferred from the statement above?
In a process, two feed streams are there and one output stream. The feed streams have the feed rates as 500 kg/sec and 600 kg/sec. If the output stream rate is 800 kg/s, what is the mass stored in the chamber in five seconds?
On moving the feed line (q-line) from saturated liquid feed (vertical position) to saturated vapor feed (horizontal feed), if the slope of both the operating lines are to be increased, then it will result in
As compared to rapid sand filters, slow sand filters give (i) Slower filtration rate (ii) Higher filtration rate (iii) Lesser efficiency in removal of bacteria (iv) Higher efficiency in removal of bacteria The correct answer is
As compared to rapid sand filters, slow sand filters give
(i) Slower filtration rate
(ii) Higher filtration rate
(iii) Lesser efficiency in removal of bacteria
(iv) Higher efficiency in removal of bacteria
The correct answer is