Bissoy.com
Doctors Medicines MCQs Q&A

For a process from state 1 to state 2, heat transfer in an irreversible process is given by

For a process from state 1 to state 2, heat transfer in an irreversible process is given by Correct Answer Q for irreversible<(To)*(S1-S2)

To is the temperature of the surroundings and S1,S2 are the entropies at state 1 and 2 respectively ans ΔS(universe)>0.

Related Questions

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as
A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
The scales form in heat exchanges after a period of operation and provide additional resistance to heat transfer with some heat transfer coefficient . The reciprocal of this scale heat transfer coefficient is called .
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the number of transfer units of the heat exchanger. At the condensing pressure, stream has saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to water. Take specific heat of water as 4 k J/kg K
It is better to state that “the change of state is irreversible, rather than say it is an irreversible process”.
A Carnot heat engine receives heat at 750 K and rejects the waste heat to the environment at 300 K. The net work output of the heat engine is used to drive a Carnot refrigerator, whose COP is 6.14. If the heat removal rate from the refrigerated space is 6.6 kW, determine the rate of heat supply to the heat engine?
Which of the following statements about two-phase heat exchangers are correct? Statement 1: Two-phase heat exchangers undergo phase change during the heat transfer process. Statement 2: It is used mainly in water-to-water heat transfer applications.
Consider the following statement: a) In a refrigerator the heat is taken out from the system. b) In a refrigerator the heat is given to the system. c) In a heat pump the heat is taken out from the system. d) In a heat pump the heat is given to the system. Which of the above statements are correct?