Bissoy.com
Doctors Medicines MCQs Q&A

A water-heater is covered up with insulation boards over a total surface area of 3 m2. The inside board surface is at 75°C and the outside surface is at 20°C and the board material has a conductivity of 0.08 W/m K. How thick a board should it be to limit the heat transfer loss to 200 W ?

A water-heater is covered up with insulation boards over a total surface area of 3 m2. The inside board surface is at 75°C and the outside surface is at 20°C and the board material has a conductivity of 0.08 W/m K. How thick a board should it be to limit the heat transfer loss to 200 W ? Correct Answer 0.066 m

Steady state conduction through a single layer board. Δx = kA(ΔT)/Q Δx = (0.08*3)*(75-20)/200 = 0.066 m.

Related Questions

A water-heater is covered with insulation boards over a total surface area of 3 m2. The inside board surface is at 75°C and the outside being at 20°C and the conductivity of material being 0.08 W/m K. Find the thickness of board to limit the heat transfer loss to 200 W ?
A 10 cm dia steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m2.°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be
A hot fluid is being conveyed through a long pipe of 4 cm outer diameter and covered with 2 cm thick insulation. It is proposed to reduce the conduction heat loss to the surroundings to one-third of the present rate by further covering with same insulation. Calculate the additional thickness of insulation
A steel pipe of 20 mm inner diameter and 2 mm thickness is covered with 20 mm thick of fiber glass insulation (k = 0.05 W/m degree). If the inside and outside convective coefficients are 10 W/m2 degree and 5 W/m2 degree, calculate the overall heat transfer coefficient based on inside diameter of pipe. In the diagram, the diameter of small circle is 20 mm
An electronic semiconductor device generates 0.16 k J/hr of heat. To keep the surface temperature at the upper safe limit of 75 degree Celsius, it is desired that the heat generated should be dissipated to the surrounding environment which is at 30 degree Celsius. The task is accomplished by attaching aluminum fins, 0.5 square mm and 10 mm to the surface. Work out the number of fins if thermal conductivity of fin material is 690W/m K and the heat transfer coefficient is 45k J/square m hr K. Neglect the heat loss from the tip of the fin
Which of the following statement(s) is/are incorrect? 1. Wage Boards are tripartite in nature, with representatives from workers, employers, and independent members 2. Except for the Wage Boards for Journalists and Non-Journalists, all the other wage boards are statutory in nature 3. Second National Commission on Labour has recommended against the utility of wage boards Select the correct answer using the code given below:
A spherical vessel of 0.5 m outside diameter is insulated with 0.2 m thickness of insulation of thermal conductivity 0.04 W/m degree. The surface temperature of the vessel is – 195 degree Celsius and outside air is at 10 degree Celsius. Determine heat flow per m2 based on inside area
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the number of transfer units of the heat exchanger. At the condensing pressure, stream has saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to water. Take specific heat of water as 4 k J/kg K
Consider the given statement and the following assumptions. Decide, which of the assumptions is implicit in the statement and choose your answer accordingly: Statement: The civic authority has decided that all the factories located inside the city limit be shifted outside to reduce the level of environmental pollution in the city. Assumptions: I. The pollution level in the city in future may reduce after these factories are shifted outside the city limit II. Enough usable land is available outside the city limit for these factories III. Many of these factories may shift to some other smaller towns to remain profitable
A hollow sphere (k = 30 W/m K) of inner radius 6 cm and outside radius 8 cm has a heat generation rate of 4000000 W/m3. The inside surface is insulated and heat is removed by convection over the outside surface by a fluid at 100 degree Celsius with surface conductance 300 W/m2 K. Make calculations for the temperature at the outside surfaces of the sphere