Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear C if number of teeth on gear A, B and C are 40, 70 and 30.
Kripal starts driving from his home and drives 37 km towards south. From there he turns left and drives 31 km. Then he turns right and drives 27 km. Then he turns left and drives a certain distance of Y km. After than, he turns left and drives 57 km. Now he finally turn left and drives 58 km to reach a bank, which is exactly 7 km south of his home. Find the value of Y in Km.
Consider the following statements regarding gear tooth designing for gear drive: 1. Tooth profiles not designed as per ‘law of gearing’ will cause vibration and impact problems even at low speed. 2. As the gears go through their mesh, the pitch point must remain stationary on the line of centres. 3. In a correctly designed tooth profile, the line of action of successive instantaneous points of contact will pass through the stationary pitch point. Which of the above statements are correct?
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the tangential gear tooth force. Module of the gear is 5mm.
Following is the data for transmission system of a Gear box reduction ratios.
1st gear - 4.3 : 1
2nd gear - 3.00 : 1
3rd gear - 2.71 : 1
4th gear - 1 : 1
Final drive reduction is 5.0 : 1
The overall reduction when the vehicle is driven in 2nd gear is
A bank employee drives 10 km towards South from her house and turns to her left and drives another 20 km. She again turns left and drives 40 km, then she turns to her right and drives for another 5 km. She again turns to her right and drives another 30 km to reach her bank where she works. What is the shortest distance between her bank and her house ?
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. Calculate the tangential component of gear tooth force.
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. A pair of spur gears consist of 25 teeth pinion meshing with a 115 teeth gear. The module is 5mm. Calculate the gear ratio.
The interference between a given pinion tooth and a gear tooth can be avoided by using 1. smaller pressure angle 2. larger pressure angle 3. Less number of teeth on the gear for a pinion with predefined number of teeth 4. More number of teeth on the gear for a pinion with predefined number of teeth Which of the above statements are correct?
Calculate the tangential component of gear tooth force if power transmitted is 6kW and diameters of pinion and gear are 150mm and 210 mm with face width of tooth being 35mm. Power is transmitted at 3000rpm.