Bissoy.com
Doctors Medicines MCQs Q&A

The power transmitted by a belt is maximum when the maximum tension in the belt is __________of centrifugal tension.

The power transmitted by a belt is maximum when the maximum tension in the belt is __________of centrifugal tension. Correct Answer three times

When the power transmitted is maximum, 1/3rd of the maximum tension is absorbed as centrifugal tension.

Related Questions

The power transmitted by a belt is maximum when the maximum tension in the belt is _________ of centrifugal tension.
The power transmitted by a belt drive is maximum when the centrifugal tension as compared to the maximum tension is
The condition for maximum power transmission is that the maximum tension in the flat belt should be equal to (Where, $${{\text{P}}_{\text{c}}}$$ = tension in belt due to centrifugal force)
The condition for maximum power transmission is that the maximum tension in the flat belt should be equal to
(Where, $${{\text{P}}_{\text{c}}}$$ = tension in belt due to centrifugal force)
When the belt is transmitting maximum power, the belt speed should be (Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
When the belt is transmitting maximum power, the belt speed should be
(Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
If P1 and P2 are the tight and slack side tensions in the belt, then the initial tension Pi (neglecting centrifugal tension) will be equal to (Where, Pc is centrifugal tension)
The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. Calculate the tension in the rope of pulley C.
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
In belt drive power transmitted is given by: (Where Tt, Ts, and v are tight side tension, slack side tension and linear velocity of belt respectively)