Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In vibration isolation system, if ω/ωn, then the phase difference between the transmitted force and the disturbing force is
In vibration isolation system, if $$\frac{\omega }{{\omega {\text{n}}}} > 1,$$  then the phase difference between the transmitted force and the disturbing force is
Which of the following are the basic differences between vibration signature and noise signature? 1. Vibration signature is essentially in the frequency range zero to 100 cps whereas noise signature is in the range 20 cps to 3000 cps. 2. Vibration signature has well-defined peaks whereas the noise signal is smeared. 3. The intensities of noise signatures arc much less than that of vibration signatures. 4. Detection of vibration signature calls for a microphone whereas that of noise can do with a pickup. Select the correct answer using the code given below.
If isolation factor is negative, then what is the phase difference between transmitted and disturbing force?
Statement: Resonance is a special case of forced vibration in which the nature and frequency of vibration of the body are the same as the impressed frequency and the amplitude of forced vibration, is maximum. Reason: The amplitude of forced vibrations of a body increases with an increase in the frequency of the externally impressed periodic force.
Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
The vibration isolation for a forced vibration system is possible, when:
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
When a periodic disturbing force is applied to a machine, the force is transmitted to the foundation by the means of spring.
A machine mounted on a single coil spring has a period of free vibration of $${{\text{t}}_{\text{p}}}$$ . If the spring is cut into four equal parts and placed in parallel and the machine is mounted on them, then the period of free vibration of the new system will become