Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Two statements are given followed by four conclusions numbered I, II, III and IV. Assuming the statements to be true, even if they seem to be at variance with commonly known facts, decide which of the conclusions logically follow(s) from the statements. Statements: I. Some forms are open ended. II. All close ended are forms. Conclusions: I. No open ended are forms. II. Some close ended are open ended. III. No forms are close ended. IV. All open ended are close ended.
The boiling that takes place in forced convection boiling is popularly known as surface boiling.
The distillation carried out in such a way that the liquid with the lowest boiling point is first evaporated and re-condensed, then the liquid with the next higher boiling point is then evaporated and re-condensed, and so on until all the available liquid fuels are separately recovered in the sequence of their boiling points. Such a process is called
Consider the following statements for Nucleate boiling: 1. For water, the critical heat flux does not exceed 1 MW/m2. 2. Nucleate boiling is the most desirable boiling regime in practice because of high heat transfer rates. 3. Heat flux increases at a higher rate with increase in temperature. Which of the above statements is/are correct?
Consider the following statements regarding nucleate boiling (i) The temperature of the surface is greater than the saturation temperature of the liquid (ii) Bubbles are created by the expansion of entrapped gas oil vapor at small cavities in the surface (iii) The temperature is greater than that in film boiling (iv) The heat transfer from the surface to the liquid is greater than that in the film boiling Which of these statements are correct?
Consider the following statements.
1. When evaporation takes place, cooling takes place.
2. Evaporation takes place at all temperature, boiling takes place only at the boiling point.
3. Evaporation is a surface phenomenon.
Which of the statements given above is/are true?
User level threads are threads that are visible to the programmer and are unknown to the kernel. The operating system kernel supports and manages kernel level threads. Three different types of models relate user and kernel level threads. Which of the following statements is/are true ? (a) (i) The Many - to - one model maps many user threads to one kernel thread (ii) The one - to - one model maps one user thread to one kernel thread (iii) The many - to - many model maps many user threads to smaller or equal kernel threads (b) (i) Many - to - one model maps many kernel threads to one user thread (ii) One - to - one model maps one kernel thread to one user thread (iii) Many - to- many model maps many kernel threads to smaller or equal user threads
The temperature of the liquid is below the saturation temperature and boiling takes place only in vicinity of the heated surface. This type of boiling is known as
All the forms of matter except gases emit electromagnetic radiation continuously. The gases which electrically or thermally excited emit a certain wavelength only, then which of the following is/are true about the process (i) The spacing between the atoms in the other forms of matter is high than in gas (ii) The spacing between the atoms in gases is high than the other forms of matter (iii) The energy of the emitted radiation depends on the spacing between the atoms (iv) The wavelength of the emitted radiation depends on the spacing between the atoms 
Compound X (C5H8O2) forms a dioxime with NH2OH. On Clemmensen reduction it forms a compound which forms only one monochloro derivative. 'X' can be: