Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In vapor compression cycle having dry saturated vapor at the end of compression the refrigeration effect is given by? H1 – Enthalpy of vapor before compression H4 – Enthalpy of vapor before entering evaporator H2 – Enthalpy of vapor after compression
The ratio of existing moles of vapor per mole of vapor free gas to the moles of vapor that would be present per mole of vapor free gas, if the mixture were saturated at the existing temperature & pressure, is termed as the
The ratio of existing moles of vapor per mole of vapor free gas to the moles of vapor that would be present per mole of vapor free gas, if the mixture were saturated at the existing temperature & pressure, is termed as the
Consider the following statements for fluidized bed boilers: 1. Fluidized bed boilers produce steam from fossil and waste fuels by using a technique called fluidized bed combustion. 2. Cyclone separators are gas cleaning devices that utilize the centrifugal force created by a spinning gas stream to separate particles from a gas. 3. In a pressurized fluidized bed boiler, the combustion process takes place in a pressurized environment resulting in a compact furnace and improved combustion efficiency. Which of the above statements are correct?
Which of the following statements is correct regarding the oxidation number of Oxygen? I. The oxidation number of Oxygen in most compounds is -2. II. When Oxygen is bonded to Fluorine in compounds like Oxygen difluoride and Dioxygen diflouride, the Oxygen is assigned an oxidation number of +2 and +2 respectively. III. In peroxide, an Oxygen atom is assigned an oxidation number of -1 and in Superoxide, each oxygen atom is assigned an oxidation number of -1/2.
Consider the following statements: Combustion chamber is 1. the volume between TDC and BDC during the combustion process 2. the space enclosed between the upper part of the cylinder and the top of the piston during the combustion process 3. the space enclosed between TDC and the top of the piston during the combustion process Which of the above statements is/are CORRECT?
Which of the following are essential for a good combustion chamber of turbojet engine? 1. It should allow complete combustion of fuel. 2. It should maintain sufficiently high temperature in the zone of combustion in addition to proper atomization of fuel thus leading to continuous combustion. 3. It should not have high rate of combustion. 4. The pressure drop should be as small as possible
Consider the following statements: 1. Both Otto and Diesel cycles are special cases of dual combustion cycle 2. Combustion process in IC engines is neither fully constant volume nor fully constant pressure process 3. Combustion process in ideal cycle is replaced by heat addition from internal source in closed cycle 4. Exhaust process is replaced by heat rejection in ideal cycle Which of the above statements are correct?
In vapor compression cycle having dry saturated vapor at the end of compression the work done is given by? H2 – Enthalpy of vapor after compression H1 – Enthalpy of vapor before compression
Modified Chemical Vapor Deposition (MCVD) process is also called as an inside vapor phase oxidation (IVPD) technique.