Bissoy.com
Doctors Medicines MCQs Q&A

In transient heat conduction, the two significant dimensionless parameters are

In transient heat conduction, the two significant dimensionless parameters are Correct Answer Biot number and Fourier number

These two are dimensionless numbers. Biot number is given by the ratio of internal conduction resistance to the surface convection resistance whereas Fourier number signifies the degree of penetration of heating or cooling effect through a solid.

Related Questions

Diagram shows transient heat conduction in an infinite plane wall. Identify the correct boundary condition in transient heat conduction in solids with finite conduction
Which one of them is a correct combination? 1) Boundary Lubrication i) Dimensionless film thickness < 1 2) Hydrodynamic Lubrication ii) Dimensionless film thickness lies between 1 and 3 3) Mixed Lubrication iii) Dimensionless film thickness lies between 3 and 5 4) Elastohydrodynamic Lubrication iv) Dimensionless film thickness is greater than 5
Consider the following standard symbols for two-port parameters: 1. h12 and h21 are dimensionless 2. h11 and B have dimension of ohms 3. BC is dimensionless 4. C is dimensionless Which of the above are correct?
Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)
Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow and k = Thermal conductivity of the body)
In a power system, which of the following is/are critical clearance time of a fault related to? 1. Transient reactance 2. Sub-transient reactance 3. Reactive power limit 4. Transient stability limit
A Carnot heat engine receives heat at 750 K and rejects the waste heat to the environment at 300 K. The net work output of the heat engine is used to drive a Carnot refrigerator, whose COP is 6.14. If the heat removal rate from the refrigerated space is 6.6 kW, determine the rate of heat supply to the heat engine?
To effect a bond between two metal plates, 2.5 cm and 15 cm thick, heat is uniformly applied through the thinner plate by a radiant heat source. The bonding must be held at 320 K for a short time. When the heat source is adjusted to have a steady value of 43.5 k W/m2, a thermocouple installed on the side of the thinner plate next to source indicates a temperature of 345 K. Calculate the temperature gradient for heat conduction through thinner plate. In the diagram, the upper plate is 2.5 cm thick while the lower is 15 cm thick.
Which of the following statements is/are correct? 1) Conductor contains a large number of electrons in the conduction band at room temperature. No energy gaps exist and the valence and conduction bands overlap. 2) A semiconductor is a material in which the energy gap is so large that practically no electron can be given enough energy to jump this gap. 3) An insulator is a solid with an energy gap small enough for electrons to cross rather easily from the valence band to conduction band.
Consider the following statements for comparison of heat and work: 1. Both heat and work are transient phenomena. 2. Both heat and work are boundary pehnomena. 3. Both heat and work are path functions and inexact differentials. Which of the above statements are correct?