Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

When ignition occurs the nucleus of the flame spreads with the whirling or rotating vortices in the form of ragged burning crust from the initial spark plug ignition site.
oil and kerosene are present in ratio of 5 : 7 in a liquid. Few litres of mixture of mixture are replaced with petrol. Ratio of oil : kerosene: petrol is 35 : 49 : 18 respectively. Amount of oil removed from mixture is 21 litres less than that of petrol added to the mixture. And amount of oil removed is 6 litres less than that of difference mentioned. Petrol is replacing the mixture removed hence; quantity of mixture is not changing. What is the difference between quantity of kerosene in old mixture and amount of oil in new mixture?
The pressure, temperature and density of the mixture between the spark plug electrodes have a considerable influence on the __________ required to produce a spark.
The pressure, temperature and density of the mixture between the spark plug electrodes have a considerable influence on the . . . . . . . . required to produce a spark.
A spark is produced to ignite a homogeneous air fuel mixture in the combustion chamber of an engine, it is called spark ignition system.
In a SI engine, combustion stage I takes 1 ms and combustion stage II takes 1.5 ms when the engine runs at 1000 rpm. If stage I time duration is independent of engine speed what will be the additional spark advance necessary when the engine speed is doubled?
Which one of the statement is correct?
1. Petrol engine is a reciprocating engine
2. Petrol engine is high speed engine
3. Petrol engine uses petrol as fuel
4. Petrol engine is internal combustion engine
Which of the following spark plug increases the resistance to increase the voltage required to jump across the spark plug gap?
Which of the following are essential for a good combustion chamber of turbojet engine? 1. It should allow complete combustion of fuel. 2. It should maintain sufficiently high temperature in the zone of combustion in addition to proper atomization of fuel thus leading to continuous combustion. 3. It should not have high rate of combustion. 4. The pressure drop should be as small as possible
Consider the following statements with regard to IC engines: 1. For best fuel economy of spark ignition engines, the fuel-air mixture should be lean 2. With supercharging, the specific consumption in compression ignition engines increases 3. With increase of load, knocking tendency in compression ignition engines increases Which of the above statements are correct?