Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
একটি স্টেপ আপ ট্রান্সফরমারে, গৌণ কুণ্ডলীর পাকসংখ্যা মুখ্য কুন্ডলীর পাকসংখ্যার দ্বিগুণ। যদি মূখ্য কুন্ডলীকে কোন পরিবর্তী বিদ্যুৎ লাইনের সাথে সংযুক্ত করা হয়, তাহলে মুখ্য কুণ্ডলীর তুলনায় গৌণ কুণ্ডলীতে- (In a step up transformer, the number of turns in the secondary coil is twice to that of primary coil. If you apply an alternating current in the primary coil, then in the secondary coil compared to the primary coil-)
In the second experiment of Faraday and Henry, the primary coil is connected to the galvanometer and the secondary coil is connected to a battery. If the primary coil is rotated about its axis, then:
When the ignition switch is opened, the primary winding of the coil is connected to the positive terminal post of the storage battery.
If the first two statements are true, the third statement is :
I. Battery X lasts longer than Battery Y.
II. Battery Y doesn't last as long as Battery Z.
III. Battery Z lasts longer than Battery X.
When an electric current coil of a wattmeter is connected to the electric current path R and the voltage coil is connected between the electric current R path and the neutral side of the balanced three phase supply, it shows 10 kW. The line voltage along the phase sequence RYB is 400 V. The current drawn by the current path is 54 A. What is the new reading of the wattmeter if the voltage coil is connected between the lines B and the Y paths, even if the electric current coil is continuously present in the line R?
An electric circuit is set up in such a way that the positive terminal of a battery V is connected to a bulb B1 which is connected to a resistor R which is connected to bulb B2. B2 is finally connected to the negative terminal of the battery. Both the bulbs are glowing. If the value of R is increased, then
The parallel combination of a 6.8 kΩ resistor and a 10 kΩ resistor is in series with the parallel combination of a 2.2 kΩ resistor and a 1 kΩ resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)
Distributed winding is a type of winding in electrical machines where all the winding turns are arranged in a number of full pitches or fractional pitches. These coils are then placed in phase form or the commutator winding in slots spread around the periphery of the air gap. This type of winding used in
The simple rotating loop between pole faces connected to a battery and resistor through a switch, the specifications of this machine are radius = 0.5m, length 1m, resistance = 0.3 ohms and magnitude strength = 0.25T is supplied with 120V. Suddenly the switch is closed at t=0, what is observed in the circuit?