Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements: 1. HSS tools wear very rapidly, whereas in cemented carbide tools, even though hardness is retained, crater wear can occur due to solid-state diffusion. 2. Cutting tools made of Super-HSS, also known as cobalt-based HSS, are made by adding 2% to 15% of cobalt which increases the cutting efficiency at heavier cuts by increasing the hot hardness and wear resistance. 3. Tools failure due to excessive stress can be minimized by providing small or negative rake angles on brittle tool materials, protecting tool tip by providing large side-cutting edge angles, and honing a narrow chamfer along the cutting edge. Which of the above statements are correct?
Flank wear occurs mainly on the 1. Nose part of the cutting tool 2. Front relief face and side relief face of the cutting tool 3. Face of the cutting tool at the shortest distance from the cutting edge Which of the above is/are correct?
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image