Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The bearing is subjected to a radial load of 4000N. Expected life for 90% bearings is 9000h and shaft is rotating at 1500rpm. Calculate the dynamic load capacity.
Consider the following statements in connection with thrust bearings: 1) Cylindrical thrust bearings have higher coefficient of friction than ball thrust bearings. 2) Taper rollers cannot be employed for thrust bearings. 3) Double-row thrust ball bearing is not possible 4) Lower race, outer race and retainer are readily separable in thrust bearings. Which of the above statements are correct?
The radius of a friction circle for a shaft rotating inside a bearing is (where r = Radius of shaft and $$\tan \varphi $$  = Coefficient of friction between the shaft and bearing)
A rotor which is balanced statically but not dynamically is supported on two bearings L apart and at high speed of the rotor, reaction on the left bearing is R. The right side of the bearing is shifted to a new position 2L apart from the left bearing. At the same rotor speed, dynamic reaction on the left bearing in the new arrangement will
Consider two shafts connected with two gears as per the following options: 1. One on each shaft 2. Through an intermediate gear mounted on an intermediate shaft, and every shaft having one gear only 3. Through an intermediate gear mounted on an intermediate shaft, with the intermediate shaft having two gears, whereas the other shafts have one gear each Which of the above represent(s) a simple gear train?
A double universal joint is used to connect two shafts in the same plane. The intermediate shaft is inclined at an angle of 20° to the driving shaft as well as the driven shaft. Find the maximum speed of the intermediate shaft if the driving shaft has a constant speed of 500 r.p.m.
A double universal joint is used to connect two shafts in the same plane. The intermediate shaft is inclined at an angle of 20° to the driving shaft as well as the driven shaft. Find the minimum speed of the intermediate shaft if the driving shaft has a constant speed of 500 r.p.m.
A double universal joint is used to connect two shafts in the same plane. The intermediate shaft is inclined at an angle of 20° to the driving shaft as well as the driven shaft. Find the maximum speed of the driven shaft if the driving shaft has a constant speed of 500 r.p.m.
A double universal joint is used to connect two shafts in the same plane. The intermediate shaft is inclined at an angle of 20° to the driving shaft as well as the driven shaft. Find the minimum speed of the driven shaft if the driving shaft has a constant speed of 500 r.p.m.
Consider that modern machines mostly use short bearings due the following reasons: 1) l/d of the most modern bearings is in the range of 1.4 to 2 2) No end leakage of oil from the bearing 3) Shaft deflection and misalignment do not affect the operation 4) Can be applied to both hydro-dynamic and hydrostatic cases Which of the above are correct?