Related Questions

The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. Calculate the tension in the rope of pulley C.
Consider the following statements regarding V-belt drive : 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive 3. The groove angle is so made that the belt gets wedged in the groove  Which of the above statements are correct ? 
The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. Calculate the torque supplied to the shaft.
The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. If allowable shear stress in the shaft is 70N/mm² and torsional and bending moments are M=1185000N-mm and m=330000N-mm, find the diameter of the shaft.
The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. If bending moment on point B in horizontal plate is M and in vertical plane is m, then the net bending moment at point B is?
In short open-belt drives, an idler pulley is used in order to decrease the angle of contact on the smaller pulley for higher power transmission.
In a flat belt drive, if the slip between the driver and belt is 1%, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be
If the angle of wrap on smaller pulley of diameter 250 mm is 1200 and diameter of larger pulley is twice the diameter of smaller pulley, then the centre distance between the pulleys for an open belt drive is
When the belt is transmitting maximum power, the belt speed should be (Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
When the belt is transmitting maximum power, the belt speed should be
(Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))