Related Questions

In a laboratory test run, the rate of drying was found to be 0.5 × 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is
The disk system consists of which of the following? i. Disk ii. Disk drive iii. Disk controller
A solid cast iron disk of mass 1000kg is rotating at 350rpm. Diameter of the disk is 1m and time taken to come to stop the disk by brake is 1.6sec.Square of radius of gyration is 0.2. Calculate the angle through which disk rotated during braking period.
You are the administrator of Windows 2000 Server computer. Your computer has a span volume that consists of areas on three physical hard disks on the server. The three disks support hot swapping. You regularly backup the span volume by using windows backup. One of the disk fail, you replace the disk with a new un-partitioned disk. You want to recover the span volume and disk data as soon as possible. What should you do?
You install your boot volume on volume C on your Windows 2000 Server computer. You mirror volume C on dynamic Disk 1. Two years later, during routine server maintenance, you open Disk Management and find that the status of volume C is Failed Redundancy. The status of Disk 1 is Missing. You attempt to reactivate Disk 1, but the status of volume C does not return to Healthy. What should you do next?
Your Windows 2000 Server computer contains a stripe set with parity on a four-disk array. You convert the stripe set with parity to a dynamic RAID-5 volume. Six months later, users report that disk access on the server is slower than it had been on the previous day, You use Disk Management and discover that the status of the third disk in the array is Missing. You want to recover the failed RAID-5 volume. What should you do first?
Your Windows 2000 Server computer contains a stripe set with parity on a four-disk array. You convert the stripe set with parity to a dynamic RAID-5 volume. Six months later, users report that disk access on the server is slower than it had been on the previous day. You use Disk Management and discover that the status of the third disk in the array is missing. You want to recover the failed RAID-5 volume. What should you do first?
200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 × 10-3 kg/m2.s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)
Hard disk এর পিছনের জাম্পার সেটিং ঠিক না থাকলে যে সমস্যা হয় -i. সফটওয়্যার install করা যায় নাii. Boot disk failureiii. Hard disk not found দেখায়নিচের কোনটি সঠিক?
A solid cast iron disk of mass 1000kg is rotating at 350rpm. Diameter of the disk is 1m and time taken to come to stop the disk by brake is 1.6sec.Calculate energy absorbed by the brake if square of radius of gyration is 0.2.