Bissoy.com
Doctors Medicines MCQs Q&A

In entrained type AWJM, abrasive water jet has a velocity of around _____ m/s.

In entrained type AWJM, abrasive water jet has a velocity of around _____ m/s. Correct Answer 800

In entrained type AWJM, the abrasive particles are allowed to entrain in water jet to form abrasive water jet with a significant velocity of 800 m/s. Such high velocity abrasive jet can machine almost any material.

Related Questions

Consider the following statements with reference to Jet stream. 1. The Jet Stream is a geostrophic wind. 2. There are two permanent jet streams – subtropical jets at mid-latitudes and polar front jets at lower latitudes. 3. Temperature also influences the velocity of the jet stream. The lower the difference in air temperature, the faster the jet stream. Which of the statements given above is/are NOT correct?
Water Jet Machining (WJM) and Abrasive Jet Micromachining (AJMM or AWJM) can be achieved using how many different approaches?
A jet of water is striking at the centre of a curved vane moving with a uniform velocity in the direction of jet. For the maximum efficiency, the vane velocity is ________ of the jet velocity
Consider the following statements for air-entrained concrete: (i) Air-entrainment reduces the water demand for a given level of workability. (ii) Use of air-entrained concrete is required in environments where cyclic freezing and thawing is expectedWhich of the following is TRUE?
State whether the following statement is true or false, about Abrasive jet machining. “Using Abrasive jet machining, micro deburring of hypodermic needles can take place.”
A standard abrasive water jet machining (AWJM) system contains mixer, accumulator, catcher, etc., modules.
Given below are three quantities named A, B and C. Based on the given information, determine the relation among the three quantities. Quantity A∶  A 30 litre mixture of wine and water has wine and water in the ratio 5∶ 7. How much water must be drawn off so that the ratio of wine and water becomes 25∶ 19? Quantity B∶ A 35 litre mixture of wine and water has wine and water in the ratio 1∶ 3. How much water must be drawn off so that the ratio of wine and water becomes 1.75∶ 3.35? Quantity C∶ A 27 litre mixture of wine and water has wine and water in the ratio 3∶ 2. How much water must be drawn off so that the ratio of wine and water becomes 81∶ 11?
Water, having a density of 1000 kg/m3, leave from a nozzle with a velocity of 10 m/s and the jet strikes a bucket mounted on a Pelton wheel. The wheel rotates at 10 rad/s. The mean diameter of the wheel is 1 m. The jet is split into two equal streams by the bucket, such that each stream is deflected by 120°, as shown in the figure. Friction in the bucket may be neglected. Magnitude of the torque exerted by the water on the wheel, per unit mass flow rate of the incoming jet, is
The force exerted (in Newton) by a jet of water impinging normally on a fixed plate is (where w = Specific weight of water in N/m3, a = Cross-sectional area of jet in m2 and V = Velocity of jet in m/s)
Which of the following statements are correct for turbo-prop powered aircraft? 1. The propulsion efficiency of turboprop is higher than that of turbo-jet and rockets for low speeds up to about 800 km/hr. 2. For the same thrust the turbine in the turbo-prop aircraft is smaller than in the turbo-jet aircraft 3. For the turbo-prop the flight velocity cannot exceed the jet velocity.