Bissoy.com
Doctors Medicines MCQs Q&A

The riser is a reservoir of molten metal provided in the casting so that hot metal can flow back into the mould cavity when there is a reduction in the volume of metal due to?

The riser is a reservoir of molten metal provided in the casting so that hot metal can flow back into the mould cavity when there is a reduction in the volume of metal due to? Correct Answer Solidification

Riser is a reservoir of molten metal provided in the casting so that hot metal can flow back into the mould cavity when there is a reduction in the volume of metal due to solidification.

Related Questions

The water level in a municipal reservoir has been decreasing steadily during a dry spell, and there is a concern that the drought could continue for another 60 days. The local water company estimates that the consumption rate in the city is approximately 107 L/day. The state conservation service estimates that rainfall and stream drainage into the reservoir coupled with evaporation from the reservoir should yield a net water input rate of 106 exp (-t/100) L/day, where t is the time in days from the beginning of the drought, at which time the reservoir contained an estimated 109 liters of water. Integrate the balance to calculate the reservoir volume at the end of the 60 days of continued drought.
During rainy season, huge inflow of water takes place into a reservoir. Measures are taken to clear the reservoir while water keeps flowing into it at a constant rate. It has been observed that seven and five men can clear the reservoir in 20 and 50 days, respectively, with the initial quantity of water in the reservoir being 24 and 36 kilolitres, respectively. What is the rate of inflow of water into the reservoir in litres per day?
What will be the value of temperature of hot reservoir in a carnot cycle, if the temperature of cold reservoir is 25°C, heat absorbed from hot reservoir is 12J and heat rejected to cold reservoir is 4J?
At the mould exit of a continuous caster, the metal consisting of a solidified shell with a liquid metal core exits at the rate of 35 kg S-1. Given that the latent heat of fusion is 3 × 105 J kg-1 and the total rate of heat removal by the mould is 4.2 × 106 W, the mass fraction of solid at the mould exit is . . . . . . . .
Assume that both while solid and liquid remain at the melting point, they are in the mould.
In hot chamber die casting, the plunger is also used for taking back of unused molten metal to the gooseneck after the fulfilling of the cavity.
A single reservoir supplies the petrol to the whole city, while the reservoir is fed by a single pipeline filling the reservoir with the stream of uniform volume. When the reservoir is full and if 40,000 liters of petrol is used daily, the suply fails in 90 days.If 32,000 liters of petrol is used daily, it fails in 60 days. How much petrol can be used daily with out the supply ever failing?
A single reservoir supplies the petrol to the whole city, while the reservoir is fed by a single pipeline filling the reservoir with the stream of uniform volume. When the reservoir is full and if 40, 000 litres of petrol is used daily, the supply fails in 90 days. If 32, 000 litres of petrol used daily, it fails in 60 days. How much petrol can be used daily without the supply ever failing?
When a pattern is to be withdrawn from the mould, it is first shaken, by striking over it from side to side, so that its surface may be free of the adjoining sand wall of the mould. That causes the size of the mould cavity increases a little and a negative allowance is to be provided in the pattern to compensate the same, is known as:
In vacuum die casting, the molten metal enters into the cavity slowly as compared to the die casting.
In hot chamber die casting processes, downward motion of plunger in the gooseneck leads to injection of molten metal into the cavity with high pressure.