Bissoy.com
Doctors Medicines MCQs Q&A

In manufacturing of hole and shaft, maximum shaft diameter was 49.88 mm and minimum hole diameter was found to be 49.94 mm. It is a

In manufacturing of hole and shaft, maximum shaft diameter was 49.88 mm and minimum hole diameter was found to be 49.94 mm. It is a Correct Answer Clearance fit

When size of smallest hole is more than size of biggest shaft then it is clearance fit.

Related Questions

In the manufacturing of hole and shaft, the maximum shaft diameter was 49.88 mm and the minimum hole diameter was found to be 49.94 mm. Which of the following is correct?
In this question, a passage and a related statement have been given. Read the passage carefully and assess the statement based on it. Using knives and screws, two Russian astronauts on Tuesday took a sample of substance around a mysterious cavity of the spacecraft called the Soyuz, which was placed in the International Space Station, a Moscow official suggested that it was a break - It can also be done. In August, two months after the last visit of the vehicle, the air leak was detected in the Soyuz spacecraft due to the 2 mm air in the ISS. Roskosmos, an astronomical institute, says that cutting off the insulation on the hole and sampling the material around it and the purpose of putting a new insulation on it is to find out that this small but dangerous hole has been done on earth or Is in space. The chief of Roskosmos has said that the error of manufacturing has not been found in the investigation. Experienced astronauts had to struggle but they managed their mission. Before the spacewalk, astronauts were able to inspect the hole just from within the spacecraft. The biggest difficulty was that in the Soyuz spacecraft, the ISS was not designed to improve during adverse weather space, and no railing was also made to catch the space passengers outside the vehicle. Statement: The mysterious hole in the So yuz spacecraft was due to the error of manufacturing. Select the appropriate from the given options A - Statement is completely true B - The statement is possibly true C - the statement can not be determined D - Statement is completely false
For manufacturing of a certain amount of hole, maximum hole size was found to be 50.14 mm and minimum hole size was found to be 49.98. What will be the Tolerance in mm?
For manufacturing of a certain amount of hole, maximum hole size was found to be 50.14 mm and minimum hole size was found to be 49.98. Tolerance in mm will be
In an assembly of hole and shaft, minimum shaft diameter is 49.36 mm and maximum shaft diameter is 48.20 mm. It is an example of
In an assembly of hole and shaft, smallest hole was having diameter of 49.98 mm and largest shaft was having diameter of 49.94 mm. Minimum clearance in mm will be
In an assembly of hole and shaft, smallest shaft was having diameter of 50.16 mm and largest hole was having diameter of 50.14 mm. Minimum interference in mm will be
In an assembly of hole and shaft, smallest shaft was having diameter of 49.98 mm and largest hole was having diameter of 50.14 mm. Maximum clearance in mm will be
In an assembly of hole and shaft, largest shaft was having diameter of 50.18 mm and smallest hole was having diameter of 49.98 mm. Maximum interference in mm will be
Two shafts 'A' and 'B' are made of same material. The shaft 'A' is solid and has diameter D. The shaft 'B' is hollow with outer diameter D and inner diameter $$\frac{{\text{D}}}{2}$$. The strength of hollow shaft in torsion is _________ as that of solid shaft.