Bissoy.com
Doctors Medicines MCQs Q&A

Cutting forces can be measured using a

Cutting forces can be measured using a Correct Answer all of the mentioned

Cutting forces can be measured using a force transducer (typically with quartz piezoelectric sensors), a dynamometer, or a load cell (with resistance-wire strain gages placed on octagonal rings) mounted on the cutting-tool holder.

Related Questions

In a group of 50 students who either want to join defence forces or paramilitary forces, out of which 40 students want to join defence forces and 30 want to join paramilitary forces. Find the number of students who want to join only defence forces.
Which of the following types of inter molecular interactions or forces is/are called van der Waals forces? 1. London forces 2. Dipole - dipole forces 3. Dipole - induced dipole forces 4. Hydrogen bonding Choose the correct code:
The system of forces acting on the aircraft are propulsive forces, aerodynamic forces, gravitational forces and these result in inertial forces.
Consider the following statements: 1. HSS tools wear very rapidly, whereas in cemented carbide tools, even though hardness is retained, crater wear can occur due to solid-state diffusion. 2. Cutting tools made of Super-HSS, also known as cobalt-based HSS, are made by adding 2% to 15% of cobalt which increases the cutting efficiency at heavier cuts by increasing the hot hardness and wear resistance. 3. Tools failure due to excessive stress can be minimized by providing small or negative rake angles on brittle tool materials, protecting tool tip by providing large side-cutting edge angles, and honing a narrow chamfer along the cutting edge. Which of the above statements are correct?
Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
Flank wear occurs mainly on the 1. Nose part of the cutting tool 2. Front relief face and side relief face of the cutting tool 3. Face of the cutting tool at the shortest distance from the cutting edge Which of the above is/are correct?
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image