Bissoy.com
Doctors Medicines MCQs Q&A

What are the acceptable viscosity limits for bitumen emulsion RS-2 when tested using saybolt furol viscometer?

What are the acceptable viscosity limits for bitumen emulsion RS-2 when tested using saybolt furol viscometer? Correct Answer 100 – 300

The test is conducted as per IS 3117 and the viscosity limits are mentioned in IS 8887. The acceptable viscosity limits for RS-2 are 100 to 300. For RS-1, it is 20 to 100; for MS, it is 50 to 300; for SS-1, it is 20 to 100 and for SS-2, it is 30 to 150.

Related Questions

Statement 1: Brookfield viscometer is an example of Coaxial Cylinder Viscometer. Statement 2: Working principle of a Brookfield viscometer: Two coaxial cylinders. Liquid is filled in between them. The viscosity produces torque which is directly proportional to the shear stress.
Four political parties W, X, Y and Z decided to set up a joint candidate for the coming parliamentary elections. The formula agreed by them was the acceptance of a candidate by most-of the parties. Four aspiring candidates, A, B, C and D approached the parties for their tickets. A was acceptable to W but not to Z. B was acceptable to Y but not to X. C was acceptable to W and Y. D was acceptable to W and X. When candidate B was preferred by W and Z, candidate C was preferred by X and Z, and candidate A was acceptable to X but not to Y, who got the ticket ?
Four political W, X, Y, and Z decided to set up a joint candidate for the coming parliamentary elections. The formula agreed by them was the acceptance of a candidate of the most of the parties. For aspiring candidates A, B, C and D approached the parties for their ticket. 1) A was acceptable to W but not Z 2) B was acceptable to Y but not X 3) C was acceptable to W and Y 4) D was acceptable to W and X When candidate B was preferred by W and Z, candidate C was preferred by X and Z and candidate A was acceptable to X but not Y, who got the ticket
Consider the following statements about emulsion SBR and solution SBR. I. Solution SBR has higher content of non-rubber materials than emulsion SBR II. Solution SBR has higher molecular weight but broader molecular weight distribution than emulsion SBR III. Solution SBR has higher cis-1,4-polybutadiene content than emulsion SBR Which of the following statements are true?
Calculate the kinematic viscosity if Saybolt viscosity is 400cSt.
If the temperature of bitumen at the surface of a road rises, its viscosity reduces. This reduced viscosity allows the bitumen to creep up the surface of any water droplets which fall on the surface and cause ?
Bitumen emulsion is the most commonly used material for the bitumen and soil stabilization in any place.
Consider the following statements regarding ductility of bitumen: 1. Ductility is the property which does not permit bitumen to undergo large deformation without breaking. 2. Bitumen with high ductility are generally adhesive but do not have good cementing properties 3. Ductility must be ascertained at two different temperatures in order to pronounce on the suitability of the material Which of the above statements are correct?
Which of the following statement is/are correct? a) Penetration test on bitumen is carried out at 27°C. b) Ductility test in bitumen is carried out at 27°C. c) In softening point test on bitumen rate of increase of temperature is 2°C per minute. d) The rate of pulling of standard briquette mould specimen in ductility test is 15 mm per minute.
Statement 1: Brookfield viscometer is very robust, is supported by software and even shows values of K and n, but, sometimes particles suspended in the fluid cause problems. Statement 2: Drawbacks of plate and cone viscometer: edge-effects, turbulence and temperature effects.