Bissoy.com
Doctors Medicines MCQs Q&A

The load bearing capacity of a structural element can be increased by changing ____________

The load bearing capacity of a structural element can be increased by changing ____________ Correct Answer Span

The strengthening of an existing structural element by increasing its load bearing capacity and altering the load supporting system by changing spans by shifting or removing of supports, conversion of continuous beam to single span beam and vice versa etc.

Related Questions

Consider the following two statements regarding Bearing stiffeners provided at the location of a concentrated load: 1. Bearing stiffeners have to resist bearing and buckling loads. 2. Bearing area and the area resisting buckling load are the same. Which of the above statements is/are correct ?
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
Consider the following statements: 1. In the case of footings on purely cohesive soils, the benefit due to surcharge or depth of foundation is only marginal. 2. The bearing capacity of a footing in pure clay may be increased by increasing its size. 3. Factor of safety should be applied only to the net ultimate bearing capacity. Which of the above statements are correct?
Which of the following are the functions of lubrication in a bearing unit ? 1. To protect the bearing components from corrosion. 2. To absorb heat from the bearing unit. 3. To carry heat away from the bearing unit. Select the correct answer using the code given below
A rotor which is balanced statically but not dynamically is supported on two bearings L apart and at high speed of the rotor, reaction on the left bearing is R. The right side of the bearing is shifted to a new position 2L apart from the left bearing. At the same rotor speed, dynamic reaction on the left bearing in the new arrangement will
Cylindrical load bearing has lower load capacity as compared to deep groove ball bearing.
Output of a bulldozer is (i) Increased if drawbar HP of the tractor is increased for a given hauling distance (ii) Decreased if drawbar HP of the tractor is increased for a given hauling distance (iii) Increased if the hauling distance is increased for a given drawbar HP of the tractor (iv) Decreased if the hauling distance is increased for a given drawbar HP of the tractor
Output of a bulldozer is
(i) Increased if drawbar HP of the tractor is increased for a given hauling distance
(ii) Decreased if drawbar HP of the tractor is increased for a given hauling distance
(iii) Increased if the hauling distance is increased for a given drawbar HP of the tractor
(iv) Decreased if the hauling distance is increased for a given drawbar HP of the tractor
Consider the following statements as suggestive of the bearing capacity of soil: 1. The maximum net loading intensity at which neither the soil fails in shear nor is there excessive settlement detrimental to the structure. 2. The maximum net pressure which the soil can carry without shear failure. 3. The net ultimate bearing capacity of the soil divided by a factor of safety. Which of the above statements is/are correct?
The frictional torque transmitted in a flat pivot bearing, considering uniform wear, is (where μ = Coefficient of friction, W = Load over the bearing and R = Radius of bearing surface)