The ratio between the creep strain and elastic strain of concrete is defined as ___________

The ratio between the creep strain and elastic strain of concrete is defined as ___________ Correct Answer Creep coefficient

Creep coefficient is progressive increase in the inelastic deformation of concrete under sustained stress components and the estimation of loss of prestress due to creep of concrete is carried out by creep coefficient method.
Bissoy MCQ

Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Study the following statements regarding creep.
i) Creep is greater on curves than on tangent railway track
ii) Creep in new rails is more than that in old rails
iii) Creep is more on steep gradients than on level track
The correct answer is
Permeability in concrete is studied towards providing for, or guarding against, which of the following features? 1. The penetration by materials in solution may adversely affect the durability of concrete; moreover, aggressive liquids 'attack' the concrete. 2. In the case of reinforced concrete, ingress of moisture and air will result in corrosion of steel leading to an increase in the volume of steel, resulting in cracking and swilling of the concrete cover. 3. The moisture penetration depends on permeability and if the concrete can become saturated with water it is less vulnerable to frost action.
A concrete beam of rectangular section 100mm wide, area is 3×104, initial stress is 1200n/mm2 of 7mm diameter located at an eccentricity 50mm. Estimate the loss of stress due to creep of concrete using the ultimate creep strain method?
Elastic failure of a material occurs, when the tensile stress equals yield strength, yield point or the elastic limit. Also, the elastic failure occurs according to maximum strain theory, when the maximum tensile strain equals (where, σ = yield strength and E = modulus of elasticity)
Elastic failure of a material occurs, when the tensile stress equals yield strength, yield point or the elastic limit. Also, the elastic failure occurs according to maximum strain theory, when the maximum tensile strain equals (where, $$\sigma $$ = yield strength and E = modulus of elasticity)
The ratio of creep strain to elastic strain is known as ___________
If C is creep coefficient, f is original pre-stress in concrete, m is modular ratio, E is Young's modulus of steel and e is shrinkage strain, the combined effect of creep and shrinkage is:
The following statements (S1, S2, S3) pertain to mass concreting. Which of the following statements are correct? S1: The materials preferred for mass concrete are: Portland cement with low heat of hydration, Pozzolanas, Aggregates (coarse and fine), Water, Admixture, Coolants. S2: Slump of mass concrete shall be the same or more than ordinary concrete work. S3: Concrete with a low water cement ratio, correctly consolidated and properly cured provides durability to mass concrete work.
Consider the following statements: 1. If more water is added to concrete for increasing its workability, it results into concrete of low strength. 2. No slump is an indication of a good workable concrete. 3. Higher the slump of concrete, lower will be its workability. 4. Workability of concrete is affected by water content as well as water-cement ratio. Which of the above statements are correct?