Related Questions

Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
In diaphragm pump the piston assembly is replaced by a diaphragm and housing; these pumps are often powered by ________ and occur as double diaphragm pumps.
Which of the following heart valves are mechanical valves? i. Ball Valve ii. Autograft Valve iii. Xenograft Valve iv. Single Leaflet Valve v. Homograft Valve vi. Bi leaflet Valves
In the question two statements are given, followed by two conclusions, I and II. You have to consider the statements to be true even if it seems to be at variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statements. Statement I: No taps are nozzles Statement II: Some valves are taps Conclusion I: All nozzles are valves Conclusion II: All valves are nozzles
The flow capacity of a valve is calculated by the _________ Cv, the flow of water through a wide—open valve in U.S. gal/min for a pressure gradient of 1 psi. For a given nominal valve size the highest Cv is achieved with ball valves followed by (in decreasing order) gate, plug, and globe valves.
Statement 1: Generally needle valves are not used for liquids. Statement 2: For a unidirectional flow, non return valves are used.
In the diaphragm clutch inward movement of the throw out bearing causes the diaphragm spring to
In the diaphragm clutch inward movement of the release bearing at the centre, causes the diaphragm spring to
__________ valves utilise a flexible diaphragm (disk) against a fixed seat. Both of these allow the control mechanism to be completely sealed from the fluid without the utilization of seals or glands, although they are limited to relatively low temperatures and pressures.
Which of the following activities should be shown separately in the cash flow statement prepared as per Accounting Standard-3?
1. Cash flow from borrowing activities
2. Cash flow from operating activities
3. Cash flow from financing activities
4. Cash flow from investing activities
5. Cash flow from miscellaneous activitie