Gear pumps are mainly used in chemical installations because they pump ________

Gear pumps are mainly used in chemical installations because they pump ________ Correct Answer High viscosity fluids

Gear pumps are mainly used in chemical installations because they pump high viscosity fluids. They use two external spur gears for this purpose.
Bissoy MCQ

Related Questions

A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear C if number of teeth on gear A, B and C are 40, 70 and 30.
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. A pair of spur gears consist of 25 teeth pinion meshing with a 115 teeth gear. The module is 5mm. Calculate the gear ratio.
Following is the data for transmission system of a Gear box reduction ratios.
1st gear - 4.3 : 1
2nd gear - 3.00 : 1
3rd gear - 2.71 : 1
4th gear - 1 : 1
Final drive reduction is 5.0 : 1
The overall reduction when the vehicle is driven in 2nd gear is
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the tangential gear tooth force. Module of the gear is 5mm.
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. Calculate the tangential component of gear tooth force.
A pair of gears with many teeth; external to the gear and known as ________ in gear pumps or a few lobes in lobe pumps.
Reciprocating pumps are not able to compete with the centrifugal pump for industrial use, mainly because these pumps have
If the gear ratio for fuel pump is thrice that of the oxidizer pump, the shaft speed of fuel pump is ____________ the oxidizer pump.
একটি পানিপূর্ণ কুয়ার গভীরতা 20m ও ব্যাস 2 m. কুয়াটিকে পানি শূণ্য করার জন্য 5 HP এর একটি পাম্প লাগানো হল। অর্ধেক পানি তোলার পর পাম্পটি নষ্ট হয়ে গেল। বাকি পানি তোলার জন্য একই ক্ষমতা সম্পন্ন আর একটি পাম্প লাগানো হল। প্রথম পাম্প দ্বারা সম্পাদিত কাজের পরিমান নির্ণয় কর।(The depth and diameter of a water filled well are 20 m and 2 m respectively. An engine of 5 HP is attached to pump out the water. The pump was ruined after emptying half of the water. Then another pump of same capacity was attached to pump out rest of the water. Determine the work done by first pump.) 
6 pumps of kirlosker can fill a tank in 7 days and 2 similar pumps of USHA can fill the same tank in 18 days. what is the ratio of the efficiency of a kirlosker pump and a USHA pump?