Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The fluid coming into the airlift pump is accelerated by ________
A centrifugal pump designed to pump water is employed to pump a more viscous oil. In the later case, the pump
Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation?
1. Fluid flow is frictionless & irrotational
2. Fluid flow is steady
3. Fluid flow is uniform & turbulent
4. Fluid is compressible
5. Fluid is incompressible
একটি পানিপূর্ণ কুয়ার গভীরতা 20m ও ব্যাস 2 m. কুয়াটিকে পানি শূণ্য করার জন্য 5 HP এর একটি পাম্প লাগানো হল। অর্ধেক পানি তোলার পর পাম্পটি নষ্ট হয়ে গেল। বাকি পানি তোলার জন্য একই ক্ষমতা সম্পন্ন আর একটি পাম্প লাগানো হল। প্রথম পাম্প দ্বারা সম্পাদিত কাজের পরিমান নির্ণয় কর।(The depth and diameter of a water filled well are 20 m and 2 m respectively. An engine of 5 HP is attached to pump out the water. The pump was ruined after emptying half of the water. Then another pump of same capacity was attached to pump out rest of the water. Determine the work done by first pump.) 
A, B and C are three small pumps fitted to a tank. D is a large pump fitted to the tank. Pump B is 25% more efficient than A. Pump C is 20% more efficient than B. Pump D is 4/3rd efficient of pump C. All of the pumps are used to fill the tank. What is the ratio of the time taken by pumps A and B to fill the tank together to the time taken by the pumps B and D to fill the tank together?
A centrifugal pump which circulates a hot liquid metal at 500 degree Celsius is driven by a 3600 rpm electric motor. The motor is coupled to the pump impeller by a horizontal steel shaft of dia 25 mm. Let us assume the motor temperature as 60 degree Celsius with the ambient air at 25 degree Celsius, what length of shaft should be specified between the motor and the pump? It may be presumed that the thermal conductivity of the shaft material is 35W/m K and that the convective film coefficient between the steel shaft and the ambient air is 15.7W/square m K
A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D. of 50 mm. What head (m of water) must the pump generate at its exit (E) to deliver water at a flow rate of 0.001 m3/s? The Fanning friction factor, f is 0.0062.
Power required (in watts) to drive a centrifugal pump is (where Hm = Manometric head in metres, w = Specific weight in N/m3, Q = Discharge of the pump in m3/s and $${\eta _{\text{o}}}$$ = Overall efficiency of the pump)
A centrifugal pump used to pump water is used to pump an oil with specific gravity of 0.8 at the same rate. The power consumption will now
Statement (I): The term surge indicates a phenomenon of instability which takes place at low flow values and which involves an entire system including not only the centrifugal compressor, but also the group of components traversed by the fluid upstream and downstream of it. Statement(II): Choking is defined as separation of fluid from the rotor blades of centrifugal compressor.