Bissoy.com
Doctors Medicines MCQs Q&A

What is the disadvantage of using molecular sieves for the adsorption of nitric acid tail gases?

What is the disadvantage of using molecular sieves for the adsorption of nitric acid tail gases? Correct Answer Selectivity is low

]The main disadvantage of using molecular sieves is that they have low selectivity for nitrogen oxide adsorption. This limitation results in the simultaneous adsorption of water vapour and low collection efficiency of the target.

Related Questions

Solution-1 containing 10% nitric acid and 20% acetic acid at the rate F combines with Solution-2 containing 20% nitric acid and 10% acetic acid at the rate D, the product formed contains 30% nitric acid and 20% acetic acid at the rate P, how many independent equations containing F, D, and P are possible?
An aircraft with wing aft tail configuration has tail efficiency of 0.95 and tail volume ratio of horizontal tail is 0.7. Determine pitching moment coefficient slope for the tail. Given lift curve slope of tail is 4.2 per rad. Consider downwash derivative as 0.6.
In a batch process, the reaction takes place in the presence of an acid medium. The acid is drained from the reaction vessel at the rate of 15ml/s as a result of the density difference of the acid from the reacting component. To avoid wastage of acid, it is recycled to an acid tank which has 1000 L capacity. The acid drained from the reaction vessel, picks up 50 g/L solids from the reactor. Acid is fed once again to the process from acid tank. When the process is started, the acid is almost pure in the tank as a result of filtration. As the reaction proceeds, acid in the tank gets more and more contaminated with the solids. The concentration of the solids should not exceed 100 g/L from the process point of view. The batch time is 16h. Estimate whether the concentration of the solids will exceed 100g/L during the batch reaction.
Solution-1 containing 10% nitric acid flowing at the rate 10 Kg/min combines with Solution-2 containing 40% nitric acid flowing at the rate 5 Kg/min, if their product contains 30% nitric acid, what is the flow rate of product?
Solution-1 containing 40% nitric acid and 20% carbon dioxide at the rate F combines with Solution-2 containing 30% nitric acid and 40% carbon dioxide at the rate D, the product formed contains 30% nitric acid and 20% carbon dioxide at the rate P, If P = xF what is x?
Which adsorbent is advantageous for the adsorption of nitric acid tail gases?
Which of the following chemicals are used to treat the instruments made out of polymers? i) Ethylene Oxide ii) Hydrochloric Acid iii) Silver Cyanide iv) Ozone v) Bleach vi) Saline Solution vii) Sulphuric Acid viii) Glutaraldehyde and Formaldehyde ix) Phthalaldehyde x) Hydrogen Peroxide xi) Nitric Acid xii) Peracetic Acid xiii) Silver xiv) Formic Acid xv) Citric Acid
A typical jet transport aircraft needs to be sized based on following parameters. Wing area S=50m2, MAC=5m. If tail volume coefficient of horizontal tail is 1 and tail area is 10m2 then, find the required tail moment arm.
Which statement is correct about strong acid? Statement 1: An acid that is completely ionized in water and thus produces a very small amount of hydrogen ions is called a strong acid.  Statement 2: Sulphuric acid and nitric acid are also strong acids.
Though, theoretically the adsorption & desorption isotherms is expected to coincide but sometimes at least a part of the isotherms does not coincide and this phenomenon is known as adsorption hysterisis. In such cases, the desorption equilibrium pressure is __________ that obtained for adsorption.