Which of the following is necessary for further processing in code based positioning?

Which of the following is necessary for further processing in code based positioning? Correct Answer Receiver clock error

In pseudo ranging, code based positioning takes places, which needs a certain parameter to continue further. Those include receiver clock error and the position of co-ordinates. By using these, equations can be developed for solving the unknowns.
Bissoy MCQ

Related Questions

Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
Which of the following positioning system does the positioning system use in order to position the system?
Indoor positioning systems require higher accuracy than outdoor positioning systems.
Consider the following statements
1. In the first level of information processing, an internal representation of an object is formed
2. In the second level of information processing identification and recognition is carried out
3. In the first level of information processing identification and recognition is carried out
4. In the second level of information processing internal representation is formed
Select the correct answer from the options given below:
Given the steps of information system
1. Data processing
2. Transaction processing
3. Application processing
4. Information system processing
Which is the correct sequence of information system's steps
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure