Bissoy.com
Doctors Medicines MCQs Q&A

Calculate the chainage of P.R.C, if the chainage of Tangent is 567.54m and the curve length is about 65m.

Calculate the chainage of P.R.C, if the chainage of Tangent is 567.54m and the curve length is about 65m. Correct Answer 632.54m

The value of chainage of P.R.C can be obtained by using the formula, Chainage of P.R.C = chainage of tangent + length of arc Chainage of P.R.C = 567.54 + 65 Chainage of P.R.C = 632.54m.

Related Questions

Find the chainage of second tangent point, if the chainage at the point of compound curve is given as 2345.87m and the curve length can be given as 568.54m.
Determine the value of chainage of point of the compound curve, if the chainage at T1 is given as 226.43m and the curve length as 23.64m.
Find the value of the chainage of T1 by using the chainage of P.I and the tangent distance is given as 1024.31m and 707.57m.
Steps are given to draw normal and tangent to an archemedian curve. Arrange the steps, if O is the center of curve and N is point on it. i. Through N, draw a line ST perpendicular to NM. ST is the tangent to the spiral. ii. Draw a line OM equal in length to the constant of the curve and perpendicular to NO. iii. Draw the line NM which is normal to the spiral. iv. Draw a line passing through the N and O which is radius vector.
An aircraft is flying at cruise level with a velocity of 110m/s at an altitude of 10 km and the dynamic pressure is 5.43kN/m2. Now assume the aircraft is flying is at sea level with a speed of 65m/s and the same dynamic pressure. In the above data, the velocity 65m/s refers to __________
Find the tangential angle of the curve, if the length of the chord is given as 65m and the degree of the curve is equal to D at 100ft length.
Find the value of the long curve tangent distance, if the tangent length of short and long curves were given as 23.21m and 65.87m. The total deflection is 67˚54ꞌ and the deflection angle at short curve is given as 28˚43ꞌ.
The MC curve reaches its minimum point before the AVC curve and the AC curve. In addition the MC curve intersects the AVC curve and the AC curve at their lowest point. The above statements are both true
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Given are the steps to draw a tangent to given circle from any point outside the circle. Arrange the steps. i. With OP as diameter, draw arcs on circle at R and R1. ii. Draw the given circle with center O. iii. Join P and R which is one tangent and PR1 is another tangent. iv. Mark the point P outside the circle.