Bissoy.com
Doctors Medicines MCQs Q&A

The same contour appears on either sides of a ridge or valley, for the highest horizontal plane that interests the ridge must cut it on both sides.

The same contour appears on either sides of a ridge or valley, for the highest horizontal plane that interests the ridge must cut it on both sides. Correct Answer True

The same contour appears on either sides of a ridge or valley, for the highest horizontal plane that interests the ridge must cut it on both sides. The same is true in case of a lower horizontal plane that cuts a valley.

Related Questions

Considered the following statements about the characteristics of contours - (1) Closed contour lines with higher values inside show a lake, (2) Contour is an imaginary line joining points of equal elevations, (3) Closely spaced contour lines indicate a steep slope. (4) Contour lines of equal height may not converge nor continue as one line but a single contour line may split into two lines Which of the statements given above are correct?
Which of the following statements is/are true? i. Contour lines cross valley line at 90°. ii. Contour lines cross ridge line at 90°. iii. Contour lines are widely spaced where ground has steep slope.  
This are the following statements given regarding satellite’s motion a. A satellite in geostationary orbit lies in the same plane with equator b. A satellite in geosynchronous orbit lies in the same plane with equator c. A satellite in geostationary orbit does not lie in the same plane with equator, it is inclined at some angle from plane of equator d. A satellite in geosynchronous orbit does not lie in the same plane with equator, it is inclined at some angle from plane of equator Choose one of the following options
To constitute a matter of res judicata which of the following conditions must concur?
1. The matter directly and substantially in issue in the subsequent suit or issue must be the same matter which was directly and substantially in issue either actually (section 11, explanation III) or constructively (section 11, explanation IV) in the former suit
2. The former suit must have been a suit between the same parties under whom they or any of them claim. Explanation VI of Section 11 must be read with this condition
3. The parties as aforesaid must have litigated under the same title in the former suit
4. The court which decided the former suit must have been a court competent to try the subsequent suit of the suit in which such issue has been subsequently raised. Explanation II of section 11 is to be read with condition
5. The matter directly and substantially in issue in the subsequent suit must have been heard and finally decided by the court in the first suit. Explanation V of section 11 is to be read with this condition
A man deposited one-fourth of his capital at 16% annual interests, one-third at 15% annual interests. The remaining capital should be invested at what rate of annual interests so that he can receive an average 19% interests per year?
A line of 12 cm length is perpendicular to profile plane and the least distance from this line to profile plane is 6 cm. This is at a distance of 4 cm from the vertical plane and 5 cm from the horizontal plane. What is distance from the point on line far away from the profile plane to profile plane?
The following statements (C1, C2, C3, C4) pertain to the characteristics of different type of canals. Which of the following statements is/are correct? C1: A contour canal can irrigate command areas on both the banks. C2: It is possible to construct a contour canal with banks on one side only. C3: In the case of a ridge canal, the number of cross drainage works are maximum. C4: Side slope canal is aligned roughly at right angles to the ground contours.
A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A semi-circular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi-cricular disc and horizontal surface is i. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
An air pressure contour line joins locations in a region having the same atmospheric pressure. The following is an air pressure contour plot of a geographical region. Contour lines are shown at 0.05 bar intervals in this plot If the possibility of a thunderstorm is given by how fast air pressure rises or drops over a region, which of the following regions is most likely to have a thunderstorm?