Bissoy.com
Doctors Medicines MCQs Q&A

The minimum recommended rise of trusses with Galvanised Iron sheets is

The minimum recommended rise of trusses with Galvanised Iron sheets is Correct Answer 1 in 6

The pitch of truss depends upon the roofing material. The minimum recommended rise of trusses with galvanised iron sheets is 1 in 6 and with asbestos cement sheets is 1 in 12.

Related Questions

A user type a content on 20 sheets, each sheet consist of 55 lines, and each line can have 66 characters. The content is again retyped on another set of sheets, these new sheets have 65 lines and each line can take 70 characters. Calculate the reduction in sheets ?
The ________________ sheets are prepared by pressing flat wrought iron plates between roller with groove and then they are galvanised with the coat of zinc.
Galvanised iron sheets have a coating of
Galvanised iron sheets are protected fromrusting due to presence of a layer of
A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise -fall periods and rise and fall periods should be same. The maximum rise in follower is 30 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 45 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 55 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within first half of cam profile, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 35 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?
Which of the following statements are true/false?
1. A minimum rate of wages for the time spent by employees for the production of output is minimum time rate.
2. Minimum piece rate is the rate based on the quantity of the output employees have produced.
3. The guaranteed time rate is a minimum rate of remuneration to apply in the case of employees employed on piece work for the purpose of securing to such employees a minimum rate of wages on a time work basis.
4. A minimum rate of remuneration to apply in the case of employees employed on piece work for the purpose of securing to such employees a minimum rate of wages on a time work basis is overtime rate.