Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following loads are not considered in the design of gantry girders?

Which of the following loads are not considered in the design of gantry girders? Correct Answer wind loads

The loads considered in the design of gantry girders are vertical loads or gravity loads, longitudinal loads, lateral loads and impact loads. The vertical force is the reaction from crane girder, acting vertically downward. The longitudinal thrust is due to starting and stopping of crane acting in longitudinal direction. The lateral thrust is due to starting and stopping of the crab acting horizontally normal to the gantry girder.

Related Questions

Which of the following statements is true? A. Impact loads are equal to the sum of the magnitude of the loads actually caused and the magnitude of the loads had they been dead loads. B. Impact loads are equal to the difference between the above-mentioned entities.
Impact loads are equal to the sum of the magnitude of the loads actually caused and the magnitude if the loads had they been dead loads. State whether this statement is true or false.
Which of the following is correct regarding gantry girders?
Gantry girders are designed to resist
For gantry girders carrying electrically operated overhead travelling cranes, the lateral forces are increased by ____ for impact allowance.
For gantry girders carrying hand operated cranes, the vertical forces are increased by____ for impact allowance
When two or more loads are acting on a structure in addition to dead load, then ASCE permits the loads other than dead loads to be multiplied by a factor of (provided the result is not less than that produced by dead load and the load causing greatest effect)
As per IS 800 : 2007, what is the maximum value of effective slenderness ratio of a beam / strut/ tension member for the following cases? Case 1: Members carrying compressive loads resulting from dead loads and imposed loads. Case 2: Members always under tension. Case 3: Members subjected to compressive forces resulting from a combination of wind/earthquake actions.
The maximum slenderness ratio of a compression member which carry loads resulting from dead loads and superimposed loads
According to 1S 800-2007, what is the maximum effective slenderness ratio for a member carrying compressive loads resulting from dead loads and imposed loads?