Battens should be designed to resist transverse shear force which is

Battens should be designed to resist transverse shear force which is Correct Answer 2.5% of axial force

Battens should be designed to resist transverse shear force which is 2.5% of total axial force on whole compression member. This transverse shear force is divided equally in all parallel planes in which, there is shear resisting elements.
Bissoy MCQ

Related Questions

Battens should be designed to resist longitudinal shear equal to
Battens should be designed to resist moment equal to
Lacing shall be designed to resist a total transverse shear equal to ____ of axial force in member
The transverse shear stress acting in a beam of rectangular cross-section, subjected to a transverse shear load, is ____________
The ultimate shear force at a section of an RCC beam is 300 kN. The shear resisted by concrete is 77.5 kN. What is the shear for which shear reinforcement is required?
When the shear force due to ultimate loads is less than 0.5 times shear force of concrete then shear reinforcement is?
Which of the following factors are affecting critical shear stresses? 1. Purity of metals reduces the critical shear stress 2. Surface films greatly enhance the critical shear stress 3. Rise in temperature 4. Rate of deformation and the extent of initial deformation also help in raising the critical shear stress
Shear stress versus shear rate behavior of four different types of fluids (I, II, III and IV) are shown in the figure below.
Basic Principles of Biotechnology mcq question image
Which one of the following options is correct?
The Rheological behaviour of concrete, when represented by shear stress vs rate of shear, is characterized as Where : τ shear stress, Τ0 = (initial) yield value, μ = at-point plastic viscosity, γ̇ = at point rate of shear.
Statement 1: Considering the equation, μ_a= τ/γ = Kγ(n-1) , for pseudo plastic fluids, n<1 and they’re called Shear thinning liquids and dilatant fluids are called Shear thickening liquids as n>1. Statement 2: Cooked starch solution is a Shear thinning liquid and dairy cream is a Shear thickening liquid.