The clear spacing between effective lengths of intermittent welds should not be ______

The clear spacing between effective lengths of intermittent welds should not be ______ Correct Answer less than 16t in case of tension joint, where t is thickness of thinner plate

The clear spacing between effective lengths of intermittent welds should not be less than 16 times and 12 times the thickness of thinner plate jointed in case of tension joint and compression joint respectively, and should never be more than 200mm.
Bissoy MCQ

Related Questions

Longitudinal spacing between intermittent welds used for connection should be
In the following passage, some of the words have been left out. Read the passage carefully and select the correct answer for the given blank out of thefour alternatives. Very simply, a checklist is a list of items required, things to be done or points to be considered, used as a reminder. This is clear. Is the _______________ implication equally clear? Perhaps not. A checklist is purely objective, no _______________ is involved. That means, if the checklist is framed as a set ______ questions, the answerto every question can only be a binary “Yes” _______ “No” and nothing in between; no shades of grey. Such objectivity is the very antithesis of the education systemtoday, both in the way teaching happens and in the ____________ of the student. Is the _______________ implication equally clear? Perhaps not.
S1: While crossing a busy road we should obey the policeman on duty.
P: We should always cross the road at the zebra crossing.
Q: We must look to the signal lights and cross the road only when the road is clear.
R: If there are no signal lights at the crossing, we should look to the right, then to the left and again to the right before crossing the road.
S: If the road is not clear we should wait.
S6: We should never run while crossing a road.

The Proper sequence should be:
The growth rate of pearlite, v, and the interlamellar spacing S are given by the following relation, $$v = k.\frac{1}{S}\left( {\frac{{1 - {S_c}}}{S}} \right)$$    where Sc is the critical spacing at which the growth rate is zero and k is a materials constant. The actual interlamellar spacing observed will correspond to
Determine the torsional shear stress in the welds if P=8kN and thickness of the welds is assumed t.
A bracket is shown welded to a vertical column by means of two fillet welds. The bending stress induced in the welds can be given by
Calculate the moment of inertia about the axis parallel to welds and shift it to CG by considering thickness of welds t.
The bracket welded to the vertical plate by means of two fillet welds. Calculate the bending stress in the welds if P=40kN, leg=4mm and e=400mm.
The bracket welded to the vertical plate by means of two fillet welds. Calculate size of the welds if P=40kN, leg=4mm and e=400mm. Maximum permissible value of shear stress in the weld is 70N/mm².
In the following passage some of the words have been left out. Read the passage carefully and select the correct answer for the given blank out of the four alternatives. Books are our ______ friends. They are our guides. We can learn everything from them. The books contain all the great ______ of the world's leaders and we can learn them by reading the books. The books help us find ______ to our questions. The books never fail us. We should read as ______ books as we can. But all books are not good. So we should ______ only good books. So we should ______ only good books and read them.