Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements 1. Value of transient stability limit will be lower than steady-state stability limit 2. Transient stability limit is the maximum flow of power through a particular point in the power system without loss of stability when large and sudden disturbances occur 3. Critical clearing angle is related to the steady-state stability limit Which of the above statement(s) is/are correct?
I. All the offices on the 9th floor have wall-to-wall carpeting. II. No wall-to-wall carpeting is pink. III.None of the offices on the 9th floor has pink wall-to-wall carpeting. If the first two statements are true, the third statement is
If the first two statements are true, the third statement is :
I. All the offices on the 9th floor have wall-to-wall carpeting.
II. No wall-to-wall carpeting is pink.
III. None of the offices on the 9th floor has pink wall-to-wall carpeting.
Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load to be resisted may be taken as __________ of the total vertical load on the most heavily loaded wall or column in the group
Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load to be resisted may be taken as __________ of the total vertical load on the most heavily loaded wall or column in the group.
The main reinforcement in the toe of a T-shaped R.C. retaining wall is provided on
i) top face parallel to the wall
ii) top face perpendicular to the wall
iii) bottom face parallel to the wall
iv) bottom face perpendicular to the wall
The correct answer is
In the order of the chronological development, the longwall support systems are arranged as
P Powered support
Q Link bar and friction support
R Frame support
S Hydraulic support
Provision of intermediate lateral supports ______ lateral stability of beam
Assertion A : From consideration of structural soundness and economy of design, most codes control the maximum slenderness ratio of masonry walls and columns.Reason R : By controlling the maximum slenderness ratio, failure is by excessive stress and not by buckling. Select your answer according to codes given below:
Assertion A : From consideration of structural soundness and economy of design, most codes control the maximum slenderness ratio of masonry walls and columns.
Reason R : By controlling the maximum slenderness ratio, failure is by excessive stress and not by buckling.
Select your answer according to codes given below: