Bissoy.com
Doctors Medicines MCQs Q&A

In which fall the depth discharge relationship is unaffected?

In which fall the depth discharge relationship is unaffected? Correct Answer Trapezoidal Notch Fall

In this fall the notches could be designed to maintain the normal water depth in the upstream channel at any two discharges, as the intermediate values do not vary much. Therefore the depth discharge relationship of the channel is not affected by the introduction of the fall.

Related Questions

Two centrifugal pumps P and R are available for use in a pipe flow system and their head-discharge characteristics are as follows. Pump P Pump R Discharge (cumecs) Head (m) Discharge (cumecs) Head (m) 0 40 0 45 0.12 35 0.14 40 0.2 28 0.24 35 0.3 18 0.3 28   The following statements (S1, S2, and S3) pertain to the head and discharge values during actual operation. Neglect losses in the system. Which of the following statements are correct? S1: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 35 m. S2: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 70 m. S3: When the two pumps P and R are connected in series, the discharge is 0.3 cumecs corresponding to a head of 46 m.
Consider the following statements. I. Possibility of combining some other structure with a fall eg. regulator, road bridge etc. II. Cutting and filling are required below and above the fall should not be necessarily equal. III. The command should not be reduced due to the lowering of F.S.L and the fall may be located below the outlets. Which of the following statement is correct for site selection of a fall?
The following question, there are three statements I, II and III. Read the question carefully and mark your answer according to which statements(s) is/are sufficient to the answer the question. What proportion of liquid of type C is there in the tank of capacity 60 liters after 2 minutes if the tank is initially empty? Statement I: Three pipes P, Q, R fill the tank in 15 minutes, 12 minutes and 10 minutes respectively Statement II: When the tank was empty all the three pipes are opened and they discharge three different types of liquid Statement III: Pipe P discharge type A liquid, pipe Q discharge type B liquid and Pipe R discharge type C liquid
When a ball is allowed to fall, the time it takes to fall any distance varies as the square root of the distance and it takes 4 seconds to fall 78.40 m. How long would it take to fall 122.50 m?
Good 'Y' is the substitute for good 'X' if
1. A fall in the price of good X leads to the fall in the marginal utility of good Y.
2. A fall in the price of good X leads to the fall in the quantity purchased of good Y. Select the correct answer
A swimming pool is initially filled to a depth of 96 inches. After 2 weeks, the depth has decreased to9212 inches. Assuming that the depth decreased at a constant rate, after how many days would the water depth have reached 9334 inches?
If the ratio of GVF depth to normal depth and the ratio of critical depth to normal are equal to 0.5, calculate the rate of change of depth if the bed slope of the channel is 1 in 1300.
Consider the following statements for a power shovel:
(i) Output can be increased by reducing the angle of swing for a given depth of cut.
(ii) For a given angle of swing, output will be maximum at optimum depth of cut.
(iii) Output can be increased by keeping the depth of cut less than optimum depth.
(iv) Output can be increased by increasing the size of shovel.
In the context of the Indian economy, consider the following pairs : Term Most appropriate description 1. Meltdown Fall in stock prices 2. Recession Fall in growth rate 3. Slow down Fall in GDP Which of the pairs given above is/are correctly matched?
In a certain code language, “people way fall” is written as “di ta gi” “all fall key” is written as “se di li” “men way tall” is written as “ta za fa” What is the code for “fall” in that code language?