What is it called when a vehicle traverses on the switch from its thick end to thin end?

What is it called when a vehicle traverses on the switch from its thick end to thin end? Correct Answer Trailing direction

If the vehicle first negotiates a crossing and then traverse on a switch from its thick end to its thin end is called the Trailing direction. Turnout depends on the direction in which traffic is being diverted by it.
Bissoy MCQ

Related Questions

You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Which of the following types of connections can use full duplex?
1. Hub to hub
2. Switch to switch
3. Host to host
4. Switch to hub
5. Switch to host
The management of a school has given instruction of the driver of its vehicle not to allow any unauthorized person to board the vehicle. A similar information was pasted on the vehicle itself stated that no unauthorized person was permitted to travel in the vehicle. The driver allowed an unauthorized passenger to board and drove negligently causing an accident in which the unauthorized passenger was killed. The school management is
The defendant company has given instructions to the driver of its vehicle not to allow any unauthorised person to board the vehicle. A similar information was pasted on the vehicle itself stating that no unauthorised person was permitted to travel in the vehicle. The driver allowed an unauthorised passenger to board and drove negligently causing an accident in which the unauthorised passenger was killed. The company is:
"Heavy Passenger Motor Vehicle" means any public service vehicle or private service vehicle or educational institution bus or omnibus, the gross vehicle weight of any of which, or a motor car, the unladen weight of which exceeds
No person shall drive any motor vehicle and no owner of a motor vehicle shall cause or permit the vehicle to be driven in any public place or in any other place unless the vehicle is . . . . . . . .
To effect a bond between two metal plates, 2.5 cm and 15 cm thick, heat is uniformly applied through the thinner plate by a radiant heat source. The bonding must be held at 320 K for a short time. When the heat source is adjusted to have a steady value of 43.5 k W/m2, a thermocouple installed on the side of the thinner plate next to source indicates a temperature of 345 K. Calculate the temperature gradient for heat conduction through thinner plate. In the diagram, the upper plate is 2.5 cm thick while the lower is 15 cm thick.
S1: Production of coins starts with the buying of unmixed metals and their testing by the Assay Department.
P: These ingots are reheated until the temperature is hot enough for hot rolling.
Q: During this stage, the ingots pass through a series of rollers until they form long, thin sheets which are the thickness of a coin.
R: From these thin strips, blank discs are punched.
S: Then the metals are alloyed in oil - fired or electric arc furnaces, and cast into ingots 40 cm wide, 15 cm thick and 6 m long.
S6: The blanks are heated to soften them, then rolled so that the rim is raised and are stamped with the design of the coin.

The Proper sequence should be:
A diode circuit is so arranged that when the switch is open it’s KVL gives Ri+ 1/C ∫i dt = 0 When the switch is closed, Ri+ 1/C ∫i dt = Vs Vs is the dc supply voltage. The diode is so connected that it is forward biased when switch is closed The circuit is mostly likely be a
A circuit is so formed such that the source-R-C-diode-switch are in series. Consider the initial voltage across the C to be zero. The diode is so connected that it is forward biased when the switch is closed. When the switch is closed,