The split tube used in static cone penetration test, is commonly known as ______________

The split tube used in static cone penetration test, is commonly known as ______________ Correct Answer Split spoon sampler

The split tube sampler, used in a test for standard penetration is commonly known as split spoon sampler resting on the bottom of the bore hole which is allowed to sink under its own weight.
Bissoy MCQ

Related Questions

One test tube contains some chemical and another test tube contains an equal quantity of water. To prepare a solution, 20 g of the chemical is poured into the second test tube. Then, two-thirds of the formed solution is poured from the second test tube into the first. If the fluid in the first test tube is four times that in second, what quantity of water was taken initially.
From a large cone of volume 600 cm3, a small cone is cut whose height is 70% of the height of the large cone. If the radius of the small cone is 50% of the radius of the large cone, then find the volume of the remaining part left after cutting the small cone.
The sum and difference of the slant height and height of cone A are in the ratio 3 ∶ 1, while the sum and difference of the slant height and height of cone Y are in the ratio 5 ∶ 1. If the volume of cone A is 30% of the volume of cone B, then the height of cone A is what percentage of the height of cone B.
Curved surface area of Cone P is seven times the curved surface area of Cone Q. Slant height of Cone Q is seven times the slant height of Cone P. What will be the ratio of the area of the base of Cone P to the area of the base of Cone Q?
Which of the following statements regarding static methods are correct?
1. Static methods are difficult to maintain, because you can not change their implementation.
2. Static methods can be called using an object reference to an object of the class in which this method is defined.
3. Static methods are always public, because they are defined at class-level.
4. Static methods do not have direct access to non-static methods which are defined inside the same class.
A plane cuts a cone such that the volume of the whole cone is 125 times of the smaller cone formed. Find the height of the smaller cone if the height of the full cone is 15 cm.
A right circular cone of circular base radius R and H resting on a plane. The cone is cut by a plane parallel to the base. The new circular cone-formed has a 12.5% volume of the older cone. What is the height of the new cone?
If the radius of the base of a cone is doubled, and the volume of the new cone is three times the volume of the original cone, then what will be the ratio of the height of the original cone to that of the new cone?
What will be the volume of the shape formed by carving out a right circular cone from a hemisphere of radius R cm, such that the volume of the cone is maximum and the base of the hemisphere is the base of the cone. I. Volume of the cone is 9π cm3.  II. Ratio of the total surface area of the cone to the hemisphere is (√2 + 1) : 3.
 The following question has two statements. Study the question and the statements and decide which of the statement(s) is/are necessary to answer the question.  The height of a right circular cone is ‘h’ and radius is ‘r’. A small cone is cut-off at the top by a plane parallel to the base. At what height above the base, the section has been made? I) Height of cone (h) = 40 cm II) Volume of smaller cone ∶ volume of larger cone = 1 ∶ 30