The switching losses can contribute significantly to the total losses in converters.

The switching losses can contribute significantly to the total losses in converters. Correct Answer True

The switching losses can contribute significantly to the total losses in converters. Generally Power electronics employed in converters operate in cycles. Being repetitively switched on and switched off, they can contribute to switching losses which may contribute a significant part to the total losses in converters.
Bissoy MCQ

Related Questions

Which of the following statements are correct for the A/D converters: a) The advantage of using a dual-slope A/D converter in a digital voltmeter is that its accuracy is high. b) The number of comparators in a 4-bit flash A/D converters is 15. c) The minimum number of comparators required to build an 8-bit flash A/D converter is 256. d) The number of comparators required in a 3-bit comparator type A/D converters is 8.
Choose the correct statement(s) i) The gate circuit impedance of MOSFET is higher than that of a BJT ii) The gate circuit impedance of MOSFET is lower than that of a BJT iii) The MOSFET has higher switching losses than that of a BJT iv) The MOSFET has lower switching losses than that of a BJT
The gate-driver circuit contributes significantly to the total losses in converters.
Consider the following statements for public circuit-switching network: 1. Private branch exchange (PBX) is an application of circuit switching. 2. A switching centre that directly supports subscribers in known as digital PBX. 3. The link between the subscriber and the network, is also referred to as the local loop. Which of the above statements are correct?
Each of the question below consists of a question and three statements number I, II and III given below it. You have to decide whether the data provided in the statement are sufficient to answer the question. Two person X and Y together can make 25% of total number of bricks in 4.8 days. Another person Z can make 50 bricks in a day. What is the time taken by person X and Z together to make the total number of bricks? I. Dimensions of a brick is (3cm × 4cm × 5cm) while the dimension of a cuboids when all the bricks are put together is (72cm × 80cm × 50cm) and ratio of number of days taken by X and Y alone to make the total number of bricks is 3 : 2. II. The total number of bricks is 4800 and person Y can make 150 bricks in day. III. Total volume of all the bricks together is 1.008m3 and dimension of a bricks is (5cm × 6cm × 7cm) and time taken by Z to make total number of bricks is 200 % more than the total time taken by person Y to make total number of bricks.
What are the conditions to be satisfied by a voltage source for using it in switching regulator. i. It must supply the required output power and the losses associated with the switching regulator ii. It must be large enough to supply sufficient dynamic range line and load variations iii. It must be sufficient high to meet the minimum requirement of the regulator system to be designed iv. It may be required to store energy for a specified amount of time during power failure especially if the system is designed for a computer power supply.
The gate-driver circuit contributes significantly to the total equipment cost of converters.
Consider the following losses for short circuit test on a transformer: 1. Copper loss 2. Copper and iron losses 3. Eddy current and hysteresis losses 4. Friction and windage losses Which of the above is/are correct?
Read the given passage and answer the question that question that follow. Beauty pageants have always been believed to degrade women. But the women who participate in these pageants do not feel degraded, instead they feel empowered. Beauty pageants provide women with a platform where they can make their voice heard. It puts women in a position where they can influence people and take up a social cause to which they can contribute and get others to contribute. Which of the following argument could be made from the above passage?
In FACTS line commutated converters are generally preferred than self-commutated converters.