Bissoy.com
Doctors Medicines MCQs Q&A

Lossless line approximation is valid for EHV transmission lines.

Lossless line approximation is valid for EHV transmission lines. Correct Answer True

Lossless line approximation is valid for EHV transmission lines. This is because extra high voltage transmission lines have low resistance or negligible resistance with respect to other line parameters. The loss is generally denoted as heat which is produced due to the inherent resistive property of the line.

Related Questions

The statement concern psychrometric chart. 1. Constant relative humidity lines are uphill straight lines to the right 2. Constant wet bulb temperature lines are downhill straight lines to the right. 3. Constant specific volume lines are downhill straight lines to the right. 4. Constant enthalpy lines are coincident with constant wet bulb temperature lines. Which of the statements are correct?
How is the reactive power of the line capacitance during low loads in long EHV transmission lines compensated?
For the realization of lossless T-junction power divider using transmission lines, the characteristic impedance of the transmission line has to be real.
If the transmission co-efficient T₁ of a transmission line is 1.333 and the characteristic impedance of the λ/4 transmission line used is 100Ω, then the characteristic impedance of the transmission line is:
Considered the following statements about the characteristics of contours - (1) Closed contour lines with higher values inside show a lake, (2) Contour is an imaginary line joining points of equal elevations, (3) Closely spaced contour lines indicate a steep slope. (4) Contour lines of equal height may not converge nor continue as one line but a single contour line may split into two lines Which of the statements given above are correct?
Arrange the following stages in a sequence, such that they result in an ogee curve between two parallel lines AB and CD, such that they are the tangents to the arc. m) Join the adjacent ends B and C with a straight line. n) Divide the line BC into four parts using the points P1, P2, P3. o) Draw lines such that they pass through the points P1, P2, P3, and are perpendicular to the line BC. p) Draw the perpendicular lines through the points B and C such that they cut the lines passing through P1, P3 respectively at E and F. q) With the center E draw an arc BP2 and with center F draw an arc P2C, thus arc BP2C is required ogee curve.
A 50 Hz synchronous generator is initially connected to a long lossless transmission line which is open circuited at the receiving end. With the field voltage held constant, the generator is disconnected from the transmission line. Which of the following may be said about the steady state terminal voltage and field current of the generator?
The capacitance per unit length and the characteristic impedance of a lossless transmission line are C and Z respectively. The velocity of a travelling wave on the transmission line is
One end of a lossless transmission line having the characteristic impedance of 75 ohm and length of 1 cm is short circuited. At 3 GHz, the input impedance at the other end of the transmission line is
For a lossy transmission line, γ=0.02+j0.15 and is 20m long. The line is terminated with an impedance of a 400Ω. Then the input impedance of the transmission line given that the characteristic impedance of the transmission line is 156.13+j11.38Ω is: